Kenmore Dishwasher 665.1743590 (6651743590, 665 1743590) Parts

This flexible replacement hose routes water safely in your appliance to restore normal water flow and prevent leaks. It replaces a worn, cracked, or leaking factory hose so your appliance can operate reliably. What it does:

• Carries water between components to maintain proper appliance operation
• Helps stop leaks caused by brittle, cracked, or damaged hoses
• Compatible with original mounting and connection points when replacing the same part number
• Common symptom: visible leaks, reduced water flow, or water pooling near the appliance

• Turn off power and shut off water supply before attempting replacement
• Inspect fittings and clamps; reuse only if undamaged, otherwise replace with proper hardware
• Ensure secure, leak-free connections and verify no kinks in the hose after installation

This bearing helps the appliance's rotating assembly turn smoothly and reduces metal-on-metal wear for quieter, more reliable operation. Replace a worn bearing to address noise and movement issues that affect performance. What it does:

• Supports the drum or tub shaft so it rotates with minimal friction
• Reduces grinding, rumbling, or squeaking noises from the rotating assembly
• Helps prevent excessive wobble or vibration during spin cycles
• Limits metal wear that can lead to leaks or further component damage

• Disconnect power and water before starting work
• Inspect surrounding seals, shafts, and mounting surfaces for wear while replacing the bearing
• Use correct tools and replacement hardware; follow OEM instructions for torque and alignment

Size: 8-32 x 1/4 inch.

This small black clamp secures a hose, tube or wiring harness to prevent movement and abrasion. It's a direct-fit replacement used to keep connections stable so lines stay routed and protected during normal appliance operation. What it does

• Holds small hoses, tubing or wiring harnesses firmly in place
• Prevents chafing and accidental disconnection from vibration or movement
• Helps maintain routing to reduce stress on attached components
• Commonly used where a compact, non-corrosive clip is required

• Disconnect power before servicing any electrical appliances
• Use appropriate hand tools; avoid over-tightening which can damage hoses

This drain cover seal creates a watertight gasket between the washer's drain cover and housing to help stop leaks and keep lint and debris out of the drain pump area, restoring reliable drainage and reducing mess. What it does:

• Seals the drain cover to prevent water from leaking at the base of the tub or access area.
• Helps block lint, coins and small debris from entering the drain pump housing.
• Restores proper drainage by maintaining a secure, even seal around the drain opening.
• Can reduce recurring puddles or water on the floor near the washer's front/bottom.

• Disconnect power and turn off water supply before starting work.
• Remove the drain cover/access panel per your model's instructions and clean mating surfaces before installing the new seal.
• Press or seat the seal evenly into the cover/housing; confirm correct orientation and full contact around the perimeter.
• After reassembly, restore power/water and run a short test cycle to check for leaks.

The Latch Switch Kit, an OEM Replacement Part is designed to ensure the safe operation of your Whirlpool dishwasher. The kit includes two microswitches and a wiring harness. It prevents the appliance from running when the door is open. If defective, the door switch may prevent the dishwasher from operating even when the door is closed.

Causes of a bad door switch can include wear and tear, exposure to moisture, or a broken actuator.

Symptoms of a bad door switch include:

• Dishwasher not starting
• Dishwasher stopping mid-cycle
• Error codes related to door issues
• Dishwasher running with the door open

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

Color: light blue. Measures about 17 inches wide by 7-1/2 inches high by 3 inches deep.