Parts for Maytag MLG22PDAGW0: Pump And Motor Parts

Fixes washer that won't spin or agitate. Drive motor powers drum rotation during wash and spin cycles. Direct replacement for failed motors.

Panel mounting screw for laundry centers. Secures control panels, trim pieces, and access panels. Replace missing, stripped, or damaged screws.

Fix F20 error codes and water level issues with this washer air chamber. Connects to the pressure switch hose to regulate water fill. Easy DIY repair.

Secures washing machine hoses to prevent leaks in the water system. Replace if damaged, corroded, or connections are loose. Verify fit by part number.

Connects the outer tub to the drain pump in your washer. Replace if cracked, leaking, punctured, or worn. Includes check ball housing for proper drainage.

Secures water hoses to fittings and prevents leaks in your washer. Replace when connections loosen or clamps lose tension. Verify fit with your model.

Secures washer hoses and prevents leaks by maintaining consistent pressure. Replace if you notice water leaks or loose connections. Verify fit with your model.

Fixes water leaks, slow drainage, or cycle interruptions caused by a cracked or clogged inner outlet hose. Straightforward replacement restores flow.

Secures the drain hose to the washer cabinet or pump. Replace this retainer clip if it's broken, cracked, or missing to keep the hose properly attached.

Secures wiring bundles inside your microwave. Replace this wire tie if it's cracked, broken, or missing to keep internal wires organized and secure.

Fix a washer that won't drain or isn't pumping water. This water pump controls water flow and drainage in your laundry center. Common DIY repair.

Rubber grommet that cushions the shock absorber mounting on your washer. Replace if cracked, worn, or missing to secure shock properly and reduce noise.

This rubber grommet cushions and seals where a component passes through a panel, helping reduce vibration and prevent wear. It restores a secure fit and helps keep panels and wiring protected. What it does:

• Cushions panels or components to reduce vibration and rattling
• Protects wires or hoses where they pass through sheet metal openings
• Helps maintain a tight fit to prevent rubbing and premature wear
• Can improve noise performance when a worn grommet is replaced

• Disconnect power (and gas/water as applicable) before beginning any repair.
• Remove the surrounding panel or trim per the appliance diagram to access the grommet.
• Press the grommet into the opening until fully seated; replace any retaining clips if used.
• Inspect adjacent wiring, hoses, and mounting surfaces and replace if damaged.

Cap for your washer. Installs on the control panel or cabinet to cover openings or secure components. Replace if cracked, broken, or missing.

Mounting screw for washer assembly. Secures components and panels in place. Replace if screw is stripped, missing, or no longer holds parts firmly.

Replace your washer door boot gasket to stop water leaks and maintain a watertight seal. Fits between door and tub. Verify compatibility with your model.

Lint filter screen for washers. Traps debris and fabric fibers during wash cycles. Replace when clogged or damaged to maintain drainage. Verify fit.

End cap for laundry center control panel or housing. Replaces cracked, broken, or missing original caps. Covers exposed ends for a finished look.