Jean November 10, 2012 for Model Number GS26HSZCC6 Is the ice actuator easier to replace than the water actuator? Or is it the exact same procedure? I've replaced the water actuator before.
1 Answer Hello Jean, You would follow the same procedure to replace the ice actuator as you would to replace the water actuator. Read More...
Lucy July 22, 2012 for Model Number FRS26LH5DS5 I don't see any screws at the bottom of the cover. I need to remove and install the ice actuator part. Are you sure you have the right refrigerator?
1 Answer Hello Lucy, As per the parts explosion, I must ask if you removed the drip tray. The screws should be behind it. If there are no screws, grasp the bottom edge of the dispenser cover and pull sharply down and toward you with your knee against the door so it cannot move. This should snap it off. To re-install, hook it on at the top and bump it back on with the heel of your hand. The instructions with the screws should be correct if you listed the correct model number unless the manufacturer has incorrect information on the parts explosion. Let us know if you continue to experience problems and we can turn it over to research and get to the bottom of it. Read More...
Jr February 05, 2012 for Model Number FRS6R5ESB6 If the ice acuator door pushes open but will not reopen, So could that be broken or is the flap that holds the rod broke?
1 Answer Hello JR. You will need to remove the drip tray and remove the three screws at the bottom and lift off the front cover 241679003. The look and see what part is broken inside the dispenser. You will then be able to see if the actuator 241681903 is bad in the dispenser. Hope this helps. Read More...
1 Answer Hello Broke. Yes, when the actuator is pressed, it makes contact with the micro-switch 241689106. This sends the power to the auger motor. Hope this helps. Read More...
Joe June 28, 2011 for Model Number frs3r3jb4 Is the actuator the part that hits the switch to make the auger run to get ice?
1 Answer Hello Joe. Yes, the actuator 241681903 is the part that when pressed, activates the micro-switch 241689106, and sends power to the auger motor. Hope this helps. Read More...
B.C. Jeppson April 07, 2011 for Model Number FRS26H5ASBA How do you remove a broken "Actuator-Ice" and install a new "Actuator-Ice" pt # AP3965488?
1 Answer Hello B.C. You will need to remove the front cover of the dispenser assembly. There are two screws at the bottom of the cover and then the cover slides off. Once removed, the actuator snaps in and out for replacement. Hope this helps. Read More...