Bobbie December 14, 2022 for Model Number Frigidaire Dishwasher FGHD2465NW1A Dishwasher was working fine. One day, my coffeemaker overflowed and dripped onto the top of the dishwasher door. (controls are on top of door). I cleaned it immediately. Two days later, my dishwasher worked fine, but the next time I tried to run it, it wouldn't start and an error code appeared: washing drying Er +S. Does that mean I have to buy a new control panel, or is there a part on the panel that could be replaced? I'm not sure I want to invest $320 in a new control panel, so I'm going to clean the connections on the ribbon cable. I read they can get stuck. True? Any tips? Suggestions? Thank you very much.
1 Answer Bobbie, This will be an issue with the control panel that will need to be replaced. Read More...
Dawn December 28, 2020 for Model Number FGHD2465NW1A I would like to confirm my thoughts that part # 807545701 will correct my problem as the replacement part is not that cheap. When I push the start button on control panel nothing happens, however if I peel back the plastic cover and apply some rubbing alcohol onto the contact, but back the plastic, in now works and the dishwasher goes on. Is my diagnosis correct and this part will fix it? Thank you
1 Answer Dawn, based on the information provided, the failure would indeed be in the console assembly 807545701. Read More...
Terry June 07, 2018 for Model Number FGHD2465NF1A Went to use it hit the start button and but the unit is dead. Has 120Vac, door switch has continuity and can hear a slight click when I activate the door switch like a relay inside the washer. The display is not lit unless I press the "my favorites" button. Then the display lights up on the top along with the timer display on the front. Doesn't display an error code just 99 as normal. What else should I have a look at?
1 Answer Hello Terry, If the display is lighting up[ but you can get no response from the touch panel, you should check the connection from the display to the control board ribbon cable. If good, replace the control board 5304514670. If this does not correct the issue, the next suspect would be the touch panel 807545704. Read More...
Barb November 10, 2017 for Model Number FGHD2465NW1A My dishwasher was flashing uO and ER error messages. I did livechat with Frigidaire... they indicated that the uO was "dealing with the venting," and the ER was a "possible switch failure." We replaced the vent assembly. I then turned on the 'quick wash' to test it (should have been 48 minutes)... it switched itself to 99+ minutes on the display, which is the time for a normal wash. It seems to be running ok now, but I'm wondering why it switched itself out of the mode that I selected. The 'quick wash' light is on. Thanks!
1 Answer Barb, This could be a keypad error in which you would need to get the console assembly 807545701. Read More...
Teresa H December 01, 2013 for Model Number FGHD2465NWOA I have Frigidaire dishwasher model #FGHD2465NWOA. The error code says the touch pad is bad. How do you install a console assembly in this dishwasher, or is that something best done by a repair man?
1 Answer Teresa, To replaced the console on your dishwasher. Remove the screws at the top of the inner panel and the console should drop down to be removed. You will need to remove the latch assembly and the control board. Install on new console and reinstall on the unit. Read More...