Jim April 03, 2015 for Model Number FRS3R5EMB0 Water dispenser not putting water out of the discharge tube, but water comes out from behind the label area. How do I disassemble the dispenser trim to get at the tubing connection? I suspect the tubing has cracked or become disconnected from the discharge tube. Thanks
1 Answer Hello Jim, You will need to remove the drip tray and the two screws at the bottom of the dispenser cover. It should then lift up and un-hook from the top. This will allow access to the screws retaining the dispenser module. When removed, you should be able to slide the water line out by dis-connecting it from the connection at the lower door hinge. Read More...
Brad August 15, 2014 for Model Number FFHS2311LW6 I push the ice button in. It did not give me ice. The water works.
1 Answer Hello Brad, This can be a poor connection at the door hinge, a bad switch 241689106, a broken dispenser module 241680505, or the water valve 242252702. The water valve is the most likely suspect. Read More...
Peggy January 11, 2013 for Model Number FRS6LE4FB0 What's the easiest way to replace the Label - Module Cover?
1 Answer Hello Peggy, Just get under the corner of the label and start lifting off. Once off make sure that you get any sticky residue off the cover assembly before putting new module cover 240570237 on. Read More...
R May 14, 2011 for Model Number FRS6R5ESB4 Can the Label Module Cover be removed and reused after repair, or is it necessry to replace it after removal?
1 Answer Hello R. It can be reused sometimes, but it is better to replace it. Sometimes when you remove it, it does not stick back on the unit good. Hope this helps. Read More...