Cort February 18, 2021 for Model Number CPEB30S9FC7 I tested the baking element with my 7 function multi tester set to the Ohm position.Listed below are the results at different setting Column 1 is each setting, column 2 is reading with tester turned to on, column 3 is reading when red & black terminals of tester are touched together and finally column 4 shows reading when terminals of the heating element are touched with red & black terminals 2000K 1 000 000 200 K 1 00.0 00.0 20 K 1 0.00 0.02 2000 1 001 017 200 1 01.5 17.1 What do these readings indicate? Is my element good or bad? What setting was the correct setting I should have used?
1 Answer Hello Cort, according to your test the bake element is within specs, (rated for 3400 watts, 16.94 ohms). As far as interpreting the rest of the readings suggest you check online for teaching videos on multimeter use. Read More...
Jo December 01, 2020 for Model Number RB160PXL I need an oven heating element for a Whirlpool oven part #255175. Can I order a replacement?
1 Answer Jo, the bake element WP866375 would be used with the model provided. Unfortunately, the broil element 865638 has been discontinued by the manufacturer and is no longer available. Read More...
Erik October 18, 2020 for Model Number REG533MN-1 I need to replace my bake element. My local parts store only has part 316075103 in stock. Can I use this one instead of the listed one: 316075101? The only difference I see is the angle of the wire clips. Thanks
1 Answer Erik, make sure the wattage and the way it mounts are the same and you should be able to use it. Be careful that the angle of the terminals do not touch or come in contact with any metal surface once it is installed. The proper part number is 5303051519 Read More...
Gary Lefave October 10, 2020 for Model Number 790.90212011 The support clips fastened to the oven baking element do not touch the oven floor. They are not in the position shown in parts diagrams for this oven element. Can they be moved to the proper location? Thanks for your help.
1 Answer Gary, Unfortunately, the brackets on the element cannot be moved and if they do not touch the floor because the element is bent up a little bit, you may need to bend it down some to get it to sit flat. Read More...
Mamu August 26, 2020 I have a gas range with no model number on it except a pin number p/n 316106128 located at the back of the range.Please kindly how can i find the model number for this gas range.Thanks
1 Answer Mamu, the model number can commonly be found on the frame of the oven cavity behind the door, on the warmer drawer, or on a plate that would be located at the top back of the range. Read More...
Dana April 18, 2020 for Model Number Frigidaire gallery 316065301 Need a bake element for the Frigidaire gallery 316065301 Which one should I be buying???
John March 31, 2020 for Model Number 317B6641Poo1 Hot Point electric stove when putting oven on and turn to temp. self cleaning light goes on and bottom element does not work top one will work
1 Answer John, The model number listed is not showing as being a good model. We will need to have the model to be able to assist with your question. Read More...
1 Answer Sharon, the bake element for the model provided is going to be part number 316075103. Read More...
Blaine Norris March 04, 2020 for Model Number FEFL68GMA How do I replace the left front burner that is under the glass?
1 Answer Blaine, Under the front of the glass in the door opening, there will be 3 screws that you will remove and then you can lift the main top-up and will have access to the elements. Read More...