Fred December 15, 2014 for Model Number FGFL67DBK Control panel cuts off by itself whether in use or not. If you tap the overlay it comes back on but will cut back off in a few minutes and the clock flashes . Tap & reset and off again in a little while. Is new control panel & overlay needed? Does tap overlay just stick on the control panel? I was a service man for a large Gas Co and am familiar with with gas appliance repairs.
1 Answer Hello Fred. 5304509983 is the part number for the oven control board. You will also need to order the overlay 316419141 as well. Read More...
Steve November 19, 2014 for Model Number Frigidaire ES300 range Everything was working on the range except for the baking portion of the oven. The stovetop, lights, clock, broiler all still work. We ordered and received a new control board and overlay as they seemed to be the diagnosis of the issue from other related posts concerning the same problem. After installing the new parts everything is still the same as before. I assume it could be the baking element itself or possibly the wires? Any ideas?
1 Answer Hello Steve, While this unit does have the ES300 control board, this still does not tell us the model you have in your home. We must have this information from your units' I.D. tag to provide you with the proper part numbers for the unit you have in your home. Without the model number, we cannot guarantee the parts will operate properly in your unit. Thank you for your patience and understanding in this matter. Read More...
Ruth January 31, 2014 When using my oven you have to hit the bake button twice and it does not always turn on. If we do get it on, it turns off chances are we have to fight to get it on again... What part does it need?
1 Answer Hello Ruth. It sounds like the control board is bad and will need to be replaced on the unit. Read More...
1 Answer Hello Karen. If it is not turning on and sending power, you will need to replace the control board on the u nit. Read More...
John B. November 18, 2011 for Model Number fgf368gca When replacing the clock/timer unit do I need to purchase also the overlay?
1 Answer Hello John. Yes, it is best to replace the overlay 316419141 with the clock assembly. Hope this helps. Read More...
2 Answers Hello Hoof! If you need the mounting bracket for the clock it is part number 316441600. Thanks! Read More...
2 Answers Hello Hoof. Looking through the parts list for your model fgf366eca I don't see any clips listed. However I do see that there is a mounting bracket that goes on the left and right side of the clock timer that holds it in place. The mounting bracket is part number 316441600. Hope this helps. Read More...
1 Answer Hello. Yes, this is easy to install. You just remove your old overlay and peel the paper off the new one, and stick it to the clock. Hope this helps. Read More...