Rodney May 26, 2014 for Model Number gltf2940fs2 I just replaced the water intake valve and water gushes between that and housing unit when I start washer. It was stored over winter. I don't see any obvious cracks
1 Answer Rodney, There should be seals in the opening where the valve goes into the dispenser assembly. You will want to make sure that the seals are not bad. If so they are not available separately and you would need to get a new dispenser assembly. Read More...
Jose March 05, 2014 My washer, model gltf2940fs1, has stopped working and no water goes in. The last load I washed, it did not make the last spin and the clothes were wet.
1 Answer Hello Jose, If the machine drained the water but did not spin you either have a bad connection, a bad motor control board 134743500, or a bad motor 137043000. You should pull the tech sheet and run the diagnostic mode to pull the fault codes for more specific troubleshooting information. Read More...
Leah January 20, 2014 for Model Number FTF2140ES0 How do you remove cracked water inlet and if any special tool for removal other then a regular household tool?
1 Answer Hello Leah! No special tools are needed. There are screws in the back of the washer to hold the top panel on. Remove those screws and slide the top panel off. Once the panel is removed you'll have access to the valve to remove and replace. Hope this information helps you, thanks! Read More...
Gary January 13, 2014 You show this item is out of stock. do you know if this will be very long of a wait ?
1 Answer Hello Gary. Sorry, the manufacturer is not showing a date. As soon as we get it, if you place an order, it will ship. You are not charged until the part ships. Read More...
Jon January 10, 2014 for Model Number PS1145692 Not sure if I have inlet with or without sensor. Can I buy w/ the sensor and if mine doesn't have it leave it "unpluged". Washer is not at location I'm at.
1 Answer Hello Jon! No, you must purchase the correct valve listed for your appliance. Thanks. Read More...
Kathleen M January 06, 2014 for Model Number GLTF2940FE1 Does the valve assembly come with the black O-ring washer? Or is this little important part available without buying the whole assembly?
1 Answer Kathleen, If you are referring to the black washers that are on the end of the valve where the water line attaches to the valve then these washer come with the hoses and not the valve itself. They should be seated in the hose where it connects to the valve. Read More...
Ruth December 09, 2013 for Model Number FAFW3921NWO My washer isn't dispensing detergent. What do I need to check?
1 Answer Hello Ruth. Try cleaning the dispenser drawer. If issue continues, replace the housing 134446130. Read More...
Scott November 22, 2013 for Model Number GE wssh300g1ww when my washer is off it fills up with water. Do you think I need a new inlet valve? wh13x10030
1 Answer Scott, Yes you will need to replace the water valve assembly 134371220 If the washer fills the tub when the washer is not in use, this indicates that one of the solenoid valve diaphragms is "seeping" and allowing water to pass into the wash basket. Read More...
Tj August 08, 2013 for Model Number ATF6000ES1 clothes will not spin dry. After washing, rinse and final spin cycle the clothes are still wet. We cleaned hose, filter and wash out the drain completely. This did not solve the problem. We then replace the control module with a new unit but this did not solve the problem either. We tried various loads and other tips in the manual and still did not work. What are your recommendations? .
1 Answer Hello TJ. You need to check and see if the lock assembly 131763256 is bad and needs to be replaced on the unit. Read More...