Tim May 31, 2012 for Model Number series 4000 aquasurge dishwasher with speed clean If I replace the vent assembly on the unit and this does not fix the Er-uo code, can I return the part?
1 Answer Hello Tim, The fault code indicates an open vent but in my experience, there could be a dis-connected wire, a detergent build-up, or the spring is corroded in to. We will replace any part ordered from us for one year from the date of order for any reason, so I'm confident that you will be satisfied with our service. Read More...
Rafael V. October 25, 2011 for Model Number PLD4555RFCO THIS MACHINE VENT IT IS ON TOP OF THE TUB. AFTER UNSCREW THE RETAINING NUT INSIDE THE VENT IS LOSE, BUT HOW DO DISCONNECT THE WIRES TO REPLACE THE NEW VENT ASSEMBLY?
1 Answer Hello Rafael. Squees the tabes at the connection on the vent assembly 5304467317 and pull the connector out of the vent assembly. Then push it into the new vent assembly and reinstall the nut. Hope this helps. Read More...
Rafael V. October 25, 2011 for Model Number PLD4555RFCO PLEASE SEND ME INSTRUCTIONS HOW TO REPLACE THE VENT ASSEMBLY PART 530446737. THE MACHINE GIVES ER UO CODES, AND ALTHOUGH I HAVE CLEANED IT STILL DOES NOT WORK. HOW TO OPEN THE MACHINE TO GET TO THAT PART. THANK YOU
1 Answer Hello Rafael. You will need to uninstall the dishwasher and unscrew the retaining nut inside the dishwasher. Once removed, the vent assembly 5304467317 can be accessed and replaced. Hope this helps. Read More...
Bill June 20, 2011 for Model Number FDB4315LFC2 "Is my Vent assembly bad if it keeps clicking and gives me an ER UO error message? I had it all apart & cleaned it thoroughly, but no difference. The solenoid keeps opening & closing." I had this same issue and I just ordered and tried installing a new vent assembly, which did not fix the problem. Is there something else it could be?
1 Answer Hello Bill. If the new vent assembly did not fix the problem, you will need to replace the control board 5304514670. Hope this helps. Read More...
Harold March 25, 2011 for Model Number AP4353774 Is my Vent assembly bad if it keeps clicking and gives me an ER UO error message? I had it all apart & cleaned it thoroughly, but no difference. The solenoid keeps opening & closing.
1 Answer Hello Harold. It sounds like the vent assembly is bad on the unit. Check and make sure all the connections are good and tight and the switches are good. Hope this helps. Read More...