Diane February 05, 2013 for Model Number GE. Model JGBP33CEH5CC Oven goes through pre heat cycle and then turns off. Oven does heat. Push several random buttons on the pad and it will go through the preheat again. Turning off and on the circuit breaker will sometimes keep it from shutting down.
1 Answer Hello Diane. Based on the information you provided, the electronic control board is bad and will need to be replaced. Read More...
Diane December 12, 2012 for Model Number JGRS14 I am F7 on my oven and last time think it was a circuit board we replaced. Is this correct for my GE wall oven.
1 Answer Hello Diane, The F7 indicates a stuck keypad and the membrane switch would need to be replaced. You would need to replace the touchpad or control panel on this unit. Read More...
Helen December 04, 2012 for Model Number jgbp33weh3ww Oven not heating correctly. Set temp at 450 shuts off at 350 and indicates it has reached requested temp. Comes on again and will get to 400 then will keep lighting and going off in rapid suscession. Have checked heat sensor, has reading of 1100 ohms at room temp. Checked the ignitor and is between 5.5 and 3.5 amps from cold to hot. Could the control panel be our problem? When you push the bake and broil buttons together, we see a F5 code.
1 Answer Hello Helen, The F5 code represents a loss of the relay drive circuit and the Control board WB27K10355 will have to be replaced. Read More...
1 Answer Hello James. Check and make sure the outlet is good and has power. If so, and the control does not work, replace the control board WB27K10355. Hope this helps. Read More...
1 Answer Hello Brian! The clock WB27K10355 has been discontinued from the manufacturer with no replacements or cross references available. Sorry! Read More...