Jim December 31, 2023 for Model Number CT9570SL2SS Upper oven failed to heat up with error code f97. However the lower oven still worked. Because I have to remove from the cabinet to replace the blower fan and control board, what other temperature sensors should be replaced while it's out of the cabinet?
1 Answer Jim, It should not be necessary to replace the thermostats unless they are faulty. Read More...
Joe August 03, 2023 for Model Number JT1000DF3BB Our wall oven cut out one day while in use. The outage appeared as though the the circuit was tripped (shut off and display went blank). In about 10 minutes the oven came back on (clock was off the time the display was blank), but no error code was present. Suspect it over heated. We tried to duplicate the issue once, but was not successful. The oven stayed on, but blower does not appear to be blowing. It sounds like something kicks on, but no air flow and no air flow sounds. I suspect something is wrong with the blower and needs to be replaced. I am suspect the blower needs to be replaced, but wanted to get your opinion. I appreciate your help.
1 Answer Joe, Using a multimeter check for power to the blower. If it has power and is not running the blower will need to be replaced. Read More...
Symone May 11, 2023 for Model Number CT9800SH5SS Do I have to remove the appliance from the cabinet to be able to replace this fan?
Eric May 11, 2023 for Model Number CK7500SH3SS My fan is making a loud noise when it runs. Is there a lubricant I need to order to make it stop or do I need to replace the fan?
Kathy March 09, 2023 for Model Number CT9050SH1SS Getting a F96 error code on the display of my GE Walloven. What does the code mean? How and what should I be testing?
1 Answer Kathy, the error F96 is going to indicate the speed of the cooling fan is below the minimum parameter. The cooling fan would need to be checked for any debris that could be stopping it up as well as testing the speed sensor WB27T11463 for a pulsing 5VDC from pin 1 to pin 2 and from pin 2 to pin 3. If the fan does not rotate during operation but there is 120VAC being applied to it, the fan WB26X31060 would need to be replaced. If the fan is rotating but there is not a 5VDC pulse at the sensor, the speed sensor board would need to be replaced. If there is not 120VAC reaching the fan during operation or it is operating and there is a 5VDC pulse at the speed sensor, the machine control WB27X25554 would need to be replaced. Read More...