Dale August 26, 2023 for Model Number WD26x21697 I have a GE dishwasher WD26x21697. For the past couple of weeks all the lights on the control panel lit up and stayed lit no matter if the door was closed or open. Now I do not get any lights. The circuit breaker is fine
1 Answer Dale, unfortunately, the model provided is not showing as a valid model. If the model number could be verified from the model serial tag and provided in a new question, this will allow the most accurate information to be presented. Read More...
Andrew June 29, 2022 for Model Number WD19X25180 I have a GE dishwasher model #WD19X25180. It will not fill with water. All lines appear to be clean and clogged. I have narrowed it down to either a float switch or the actual float itself. My issue is that I DO NOT see a float switch available to order for this model. Am I just not seeing it? Any help would be appreciated.
1 Answer Andrew, We would need to have the correct model number of your dishwasher to assist properly with your question. It would be recommended though to check to see if there is power getting to the water valve. If there is not then the control board may be the issue and if there is then the water valve will be faulty and in need of replacement. Read More...
Thomas May 21, 2021 for Model Number CDT835SSJ0SS My unit fills with water, drains water but does not pump water to spray arms? Is there a seperte pump for washing? Suggestions
1 Answer Hello Thomas, there is a drain pump motor and a separate wash/circulation motor WD26X23258. Read More...
Rashid March 07, 2021 for Model Number DEF620HMJ2es Hi I got the drain pump from your site order #12516698 for the replacement of GE dishwasher (DEF620HMJ2es) drain pump. But the electric connection is not the same and does not fit to the slot. I was suggested by your support team that it was the right replacement. Should I return the product or is there any solution to fit the electrical connections? Best, Rashid
1 Answer Hello Rashid, this drain pump kit is the manufacturer's service replacement part, it takes the place of several previous drain pumps. If needed the electrical connections would have to be modified as needed. Read More...
John H December 30, 2020 for Model Number GDF520PGD2CC The dishwasher won't drain. I ordered and replaced the drain pump and filter. ran the dishwasher it worked once and now won't drain again. I checked for restrictions in the drain hose seems ok. What else could it be? any advice would be appreciated.
1 Answer John, It is recommended to test to see if there is 120 Vac getting to the drain pump when the unit is supposed to drain. If there is not voltage then the control board will be the issue. Read More...
Robert Darrow December 20, 2020 for Model Number GDF620HMJ0ES Is this the right pump to replacement for my model of GE washer? Thanks
Rod September 12, 2020 for Model Number GDF650SGJ0WW What is the physical difference between part # WD19X25187 & WD19X24829 especially the electrical connection?
1 Answer Rod, there is a difference in electrical connection and the manufacturer recommended drain pump kit WD19X25187 would be the only one we can recommend for the model provided. Read More...
Patrick June 18, 2020 for Model Number DDT575SMF8ES I think a wine glass broke and a piece of glass(over time) has worn down the impeller on the drain pump. For a long time it made noise whenever draining during operation and during the last 2-3 minutes. Now it is quiet and most of the water drains out, none standing in the bottom of the machine but if not run daily it develops a horrible odor. I'm thinking i need to replace the drain motor assembly?
1 Answer Patrick, most dishwashers, if not run on a daily basis will start to put off an odor. There is always some water in the bottom of the sump assembly that will sour if not rinsed out. I would not replace the sump assembly just yet. Get a dishwasher tub cleaner and use it to freshen up the tub and sump. Using the dishwasher on a daily basis will also help. Read More...
Wind October 25, 2019 for Model Number GDT580SGF5WW My wife was preparing her potted flowers for the winter and had placed a load of pots (flower) into the dishwasher without rinsing off the dirt. We are now experiencing a noise when the washer is draining. My first thought was the grains of sand/dirt have entered the pump..not the pump that pumps water through the sprayers because it is normal in that mode but when the washer first start up there seems to be a pump operation that purges the system (drains it ) it appears to have a short cycle and the noise is quite apparent, then it goes into the normal wash cycles and the sound is normal..it starts the noise again at the final draining cycle just prior to the wash ending . I am looking for some help as to where and what parts l should be looking at. Will a cleaning resolve the issue or am l looking at a replacement part. I have cleaned all the tub portion..baskets, rails, filter and that is now spotless l will be removing the unit tomorrow from under the counter and need some idea as to where l should focus my search to resolve the issue. Thanks in advance!
1 Answer Wind, the drain pump section would need to be inspected as it is very likely that dirt debris has collected at the impeller and shaft of the drain pump WD19X25187. Thoroughly cleaning this section should provide a solution as long as the debris did not damage the seal in the drain pump assembly. Read More...
Francois September 10, 2019 for Model Number CDT725SSF2SS my GE dishwasher doesn't drain completely. Leave lot of water in the bottom. I checked for any obstruction in the drain but didn't find anything wrong. I'm at the point where I think it might be the drain pump. But I dont understand why it drain only partially.
1 Answer Hello Francois, if you do not have an oversudsing condition in the wash cycle,and if you have checked the drain hose and the drain pump inlet is clear then replace the drain pump part WD19X25187. Read More...