Phil February 20, 2012 for Model Number wbsr3140doww The bottom of the tub is hits the bottom of the cabinet when full, has worn a hole through and I believe it broke the pump off its bracket. None of the suspension supports are broken. Would it be best to replace them as a set? Thanks.
1 Answer Hello Phil. Yes, if one rod and spring WH16X543 is bad, it is best to replace the set on the unit. Hope this helps. Read More...
Bigb February 06, 2012 for Model Number wcsr2090g8ww How to install and remove a rod and sring asm in the back?
1 Answer Hello BigB. Remove the front panel and remove the top of the washer. Then lift upward on the old rod and slip it out of the holder. Then you will drop it out of the bottom of the tub assembly. Reinstall with the new rod WH16X543 in reverse order. Hope this helps. Read More...
Roy A. August 15, 2011 for Model Number S2100G5WW Can the suspension rods be adjusted? The bottom drive pulley is rubbing on bottom of housing.
1 Answer Hello Roy. No, based on the information you provided, it sounds like the rods WH16X543 is bad and will need to be replaced. Hope this helps. Read More...
Ginny August 05, 2011 for Model Number WCXR1070T5WW Should the suspension rods be a little stiff and there is minimal movement of the tub by pushing. Or should the suspension rods be allow for alot to movement of the tub? Thanks
Will March 21, 2011 for Model Number wprb9110 GE Profile Washer variable speed motor: the Unit is aprox 6 yrs old and the tub seems to be doing an extra amount of the Hoola ... A LOT of banging around VIOLENTLY durring SPIN cycle, especially with heavy items like towels. Graping the agitator it is very easy to "rock the boat". No resistence to moving tub back and forth, side to side. I believe its something busted in the 2 suspension rod(s)like this one. These control the "out of balance" movment, true? What do you think? Thanks!
1 Answer Hello Will. Remove the front panel and inspect the suspension rods and the brackets they attach to. Hope this helps. Read More...