Mike July 23, 2017 for Model Number Sharp KB-5121K. Microwave drawer Got a piece of mica to replace the broken piece from the top of drawer but don't know how to fasten it. Tape works for 2 - 3 days but then falls off. Help
1 Answer Mike, Unfortunately we do not have any information on Sharp microwaves to be able to assist with your question. Read More...
Mike July 07, 2017 for Model Number Sharps microwave drawer Microwave wave guard came off inside top of drawer. I got a piece of mica to replace old one but how do I attach it? Glue? I was told they don't make this design any longer but it's great and I want to use it as long as I can.
1 Answer Hello Mike, While many of these adhere to the top with silicone, we would actually need the model number from the units' I.D. tag to give you specific instructions for the particular model in your home. Thank you for your patience and understanding in this matter. Read More...
Betty May 03, 2017 for Model Number WMH53520CS I have purchased a new Whirpool microwave. The bracket to mount the appliance has to be mounted lower than the length of my wall which is 15 1/4 inches. Is there a full wall bracket that outside clips are 28 3/8 inches. I am replacing a whirpool appliances that was mounted on a full wall bracket but was manufactured in 2000. Do I need to get a smaller appliance?
1 Answer Sorry Betty. They only list 1 wall mount for the model number you provided. You may have to go with a different model or brand for your situation. Read More...
Dan April 22, 2016 for Model Number SCA1001KSS01 My Advantium 120 is arching from the plate on the right side of unit. There is a hole in the plate and I am wondering if replacing the plate will solve the problem or if there is another problem that caused the hole to be burned through the plate.
1 Answer Hello Dan, This complaint is due to moisture getting into the magnetron tube. This is corrected by replacing the magnetron WB26X26221 and the mica wave guide cover WB06X10311. Read More...
Darla January 06, 2014 Just purchased a Kenmore Elite counter micro wave. Unpacking and wondered if I should remove the plastic film cover on the inside of the micro wave window covering the glass on the inside. I thought I should, but didn't want to do the wrong thing and cause any other problems. Thank you for the advice.
1 Answer Hello Darla. It is best to contact the manufacturer and see if it is packing materials or not. Thanks. Read More...
Vicki August 04, 2013 for Model Number JVM1490BH02 I cleaned the oven today and the 5 3/4" X 4 1/2" thin cardboard like metallic colored cover on the inner right hand wall ripped off. There was one screw at the lower right side of it holding it on. I turned off the circuit breaker and removed the screw and took down the rest of it. I want to buy the replacement part. My GE microwave convection is a mounted one over the stove top.
Rich October 26, 2012 for Model Number sca1000 I'm getting arcing from the left sidewall of my microwave. I believe it's coming from what's called the wave guide cover. The cover has a burn hole in it. Will replacing the cover prevent the arcing or is the arcing a sign of something more serious. Thanks
1 Answer Hi. The wave guide part # WB06X10311 needs to be replaced after the arched area is sanded to the bare metal and repainted a few times after drying. The most likely reason is that the microwave magnetron part # WB27X10309 tip is shorted. Remove the cover and see if the mag. tip is melted. Use a volt/ohm meter part # MA-DM1 to assist you in your diagnostics. Change the diode part # WB27X10037 if it reads either 0- ohms (-or-) open (infinity) both ways. Thank You. Read More...