Bryan W April 23, 2013 for Model Number LG LSC27950SB My water dispenser has stopped working. The ice still works though. After reading through multiple post I ordered the part number 5221JA2006D. I went to put the part in and my water valve has 4 solenoids instead of the three that the new part has on it. After speaking with LG I got the part number for the wiring harness. My issue is that one of the locking collars(the orange one) is larger than the blue hose is and will not lock the hose into position. Is there a conversion kit or something else I can do to get this installed?
1 Answer Bryan, The orange fitting is a 1/4" and the tubing is 1/4" and should fit into the opening. There is no special adapter for the connection. Read More...
Bob S. April 20, 2013 for Model Number LG LSC27950st My ice maker gets water intermittently. It will fill with water 2 or 3 times then the next time it will dump ice and not fill with water. I can fill it with water and it works ok but no refill. Then it may refill again. Is it the solenoid or ice maker? I hate to waste all that money for a water valve. Thanks!
1 Answer Hello Bob, If the ice maker will fill with water sometimes, the fill tube cannot be stopped up and this points away from the water valve. This sounds more like a bad set of contacts in the ice maker that energizes the water valve. I would replace the ice maker assembly first as long as the fill tube is verified to be clear. If ice is found in the fill tube, the water pressure or the water valve is the issue. Read More...
L.J. April 13, 2013 for Model Number LFX25975ST SN 903KRVQO1023 The plate a water glass presses against to dispense water slips off to one side when the glass is pushed against it. Has causes it to stick. The button that can be finger pressed above works fine. Did not see this item on your parts. A front view of the frig. would help.
1 Answer L.J., the water dispenser button assembly that you press your glass against to release the water is part number ABH37000107. Thanks! Read More...
Jaclyn April 02, 2013 for Model Number Lsc27914st We are no getting water to are ice maker but we have water from the water dispenser
1 Answer Jaclyn, There is a test button on the bottom of the icemaker motor. Push this test button to see if the icemaker cycles. If it does not then the icemaker would need to be replaced. If it does and water comes into the icemaker then the main control board is faulty and if it does not bring water in then the water valve would be the problem. Read More...
Jack Ofall Trades March 17, 2013 for Model Number LG LSC26905TT I own an LG LSC26905TT Fridge/Freezer with built in icemaker and water dispenser. The water dispenser does not output any water and the icemaker does not make ice. Do you think the problem is the water inlet valve which is part # 5221JA2006D?
1 Answer Jack, There are a couple of possibilities the diodes in the wire harness 6877JB3019F may have failed and is not allowing the power to the valve, or one of the fill valve solenoids have failed and has stopped the water flow. As long as you're sure the water filter is clean and properly seated that would be a good place to start. Read More...
Laurence March 12, 2013 for Model Number LSC26905TT I attempted to replace the two water tubes on my LG LSC26905TT but ran into difficulties when attempting to connect into the water valve. When I removed the old damaged tubes, I pulled them from the valve fitting. In so doing I found a strange looking washer that I suspect is used to hold the tubes into the fitting. These washers were damaged when I pulled them out. I understand that to get these washers, I have to buy the complete water valve. I don't want to damage anything else when I remove the other remaining tubes from the current valve. What is the best way to take them off the old valve, and what steps should I follow to secure the new tubes to the new water valve?
1 Answer Laurence, The clips that are in between the ring and the valve need to be removed. Once you remove the clips you will push in on the ring and pull out on the tubing. Read More...
Tony W. March 02, 2013 for Model Number lsc26905tt water inlet valve I have replaced my water inlet valve for my lsc26905tt with a replacement part from your company. I originally had an issue where water was coming out from under the fridge when we would get water from the dispenser or the ice maker was working. Everything was fine until a few weeks after the installation and now we are experiencing the same problem. Any ideas on why this is happening? and do I have another problem. BTW I have replaced my water filter also when the inlet valve was replaced. Thanks ahead of time...Tony
1 Answer Hello Tony. Make sure the water lines on the unit are not leaking and also, check and see if the drain hole in the freezer is clogged and needs to be cleaned out. Read More...
Yvonne February 09, 2013 for Model Number LG LRSC26912SW Hi. We can not get ice or water to dispense from the front of the unit. Ice is produced just fine and the lights are on to indicate the temperatures on the front panel but no ice or water will come out. In addition the light button on the dispenser is illuminated but no light ever comes one. Any suggestions?
1 Answer Hello Yvonne, If the connections at the door hinge are making correctly, the control board 6871JB1352A has failed. Unfortunately, the board is no longer available and the manufacturer has provided no satisfactory substitute. I tried to send you an e-mail with some additional information but "Delivery to the following recipient failed permanently: Google tried to deliver your message, but it was rejected by the server for the recipient domain." Read More...
Jim D January 25, 2013 for Model Number LRSC26925TT I filled my coffee pot with water last night from the water dispenser fine. When I got up this morning, no water from the dispenser. I heard the ice tray empty and checked that, no water in the tray now either. I can't hear the pump activating any more either. It still dispenses ice though. Most likely the water pump? Is this something I can replace or will I need to hire someone (I'm moderately capable)?
1 Answer Hello Jim, The first thing that you always want to check is that the water filter is good. The chances of both solenoids for the water valve going bad is unlikely. The water filter or the filter head would be the most likely cause. If the filter head is bad it will not put water into the icemaker or dispense water. The same with the filter. Most units come with a filter bypass that you could install and see if the ice and water work. If not then you would want to pull the water lines from the valve and press the dispenser and see if water comes through. If it does then you will want to replace the filter head. If no water then you want to check for 12 vdc to the valve when calling for water at the dispenser. If no power then the control board would be at fault/ Read More...
Henry G November 29, 2012 for Model Number lsc26905tt I get ice cubes & crushed ice but no drinking water. At first there was a pump noise but no more, ice tray filles up ok.
1 Answer Hello Henry, You will want to test to make sure that you are getting power to the water valve. When dispenser lever is pushed you should have 12vdc at the water valve. If you have this voltage then you need to replace the water valve 5221JA2006D. Read More...