Betty W October 09, 2016 for Model Number RF323TEDBWW/AA-0001 I need to know how to disassemble the ice maker in the freezer. It is always breaking.
1 Answer Betty, The icemaker in the freezer will come out by removing the 2 screws at the front of the icemaker. Then to get the motor assembly out of the support, there will be a tab on the support that holds the icemaker in place, Push on the tab and slide the icemaker motor from the support. Read More...
B Walker October 07, 2016 for Model Number rf323te Model rf323te this refrigerator has two ice makers. The one in the freezer keeps breaking down. I am tried of getting it fixed. Can I disconnect it? Thank you.
1 Answer Yes, You can disconnect the ice maker from the refrigerator. You'll need to remove the ice maker to disconnect the wire harness from the assembly. You may also want to cover the wire harness end with electrical tape to keep moisture and condensation out of the connector. Good Luck and Thanks, Read More...
Bryan S. September 18, 2016 for Model Number RF260BEAESR/AA-0001 I need the complete icemaker assembly. Thanks
1 Answer Hello Bryan, The complete icemaker assembly is DA97-07603B for the model provided. Read More...
Chuck September 16, 2016 for Model Number RF220NCTABC The guide for the ice maker that allows the ice maker to stop making ice got jammed in the drawer and broken. I have been attempting to get just that part and the part I found on line was not the right angle and didn't work. I attempted to locate it though your chat line and that was absolutely no help for the csr had no idea what the part was. Can I purchase just the ice guild for this unit?
1 Answer Chuck, The manufacturer does not list the arm for the icemaker on your model as a separate part. This would require the icemaker to be replaced in order to replace the arm. Read More...
Robert September 06, 2016 for Model Number RF323TEDBSR/AA-0001 Bottom freezer leak in middle outside back water line screws onto do you know what that part is called.
1 Answer Robert it sounds like you would be referring to one of the water tubes that is leaking and would need to determine which line it is. This will be especially if the leaking is on the back of the unit on the outside wall in the middle. Read More...
Phillip September 04, 2016 for Model Number RF266ABRS/XAA I'm need to replace my ice maker. Is it sold as one part?
1 Answer Phillip, The part number for the complete icemaker assembly on your unit is DA97-07603B. Read More...
Randy September 03, 2016 for Model Number RF323TEDBSR/AA-0001 What's the difference between ice maker DA97-07603B and DA97-07603A? Thank you
1 Answer Randy, Unfortunately we do not have information on the difference of these 2 icemakers. There may be a wiring difference but you should always use the one your unit calls for unless it is substituting to another part then use the substitute part. Read More...
Bert September 03, 2016 for Model Number RF26HFENDSR/AA Ice maker doesn't cycle. Pressing test button will cause it to dump ice and refill properly, but it doesn't ever cycle on its own. The ice-bin-full arm does come down during a test cycle, and the bin is empty. Does the icemaker DA97-07603B have the cycle timer built in or is it part of the control panel on this model? Can the cycle timer be purchased separately? Thanks
1 Answer Hello Bert, The part in the icemaker that cycles it is the icemaker cycling thermostat. It should close and initiate a cycle at about 20°F. If not, you will have to replace the icemaker assembly DA97-07603B. Read More...
Tiff July 06, 2016 for Model Number RF266ABPN/XAA My ice maker overflows and the ice bin freezes in one solid chunk. When I looked at the ice cube tray, it was overfilled and frozen solid, with frozen drips hanging down from it. I used a blow dryer to melt the ice, and then reset the ice maker. It dumped the ice, but when I turned the ice maker back on, the ice bin still filled up with water and started to freeze. I'm not sure if maybe it's dumping the ice too soon, so the unfrozen water is filling the bin, and the rest of the ice left in the tray makes the tray overflow when being refilled? and it just keeps repeating until the whole tray is frozen over? any help? or should i just replace the whole ice maker? thank you!
1 Answer Hello Tiff. If the icemaker is overfilling, replace the water valve. However, if the icemaker is leaking, just replace the icemaker. Read More...
Wayne June 21, 2016 for Model Number RF265AAWP/XAA-0000 My Ice maker stop producing ice. I have change the filter since it was showing the filter replacement indication light. I also use the RESET on the ice maker. It does dump the ice and refills when I the RESET, but after that it will not dump the ice. I am not getting any error codes.
1 Answer Hello Wayne. If the temp is correct, you will need to order and replace the icemaker on the unit. Read More...