Shane December 09, 2013 for Model Number JDS9860AAP The part number on the control panel label is 7601P655-60 Rev. 0. Neither of the control panels you offer for my model are stated to replace this #?
1 Answer Hello Shane. We will need the serial number of the unit to get you the correct board for the unit. Read More...
Andy November 26, 2013 for Model Number JDS9860AAP Oven will not heat above 250degrees when set to bake 350. Bottom element does not heat. But if I preheat the oven by setting it on Broil-Hi for 10 minutes, then hit clear/off, then set it to bake 350 and it will hold the temp. Does this sound like a control or sensor problem?
1 Answer Hello Andy. I would test the voltage and the bake element. It is leaning toward one of them being bad. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Michael K. March 20, 2013 for Model Number jds9860aap Oven goes from bake to broil and won't turn off. I have to cut power to clear.
1 Answer Hello Michael. Based on the information you provided, it sounds like the control WP5760M301-60 will need to be replaced in the unit. Read More...
Mike November 13, 2011 for Model Number JDS9860AAP how do you take the controller AP4426684 out to replace it?
1 Answer Mike, Here's some access information : "Control Panel 1. Remove power from unit. 2. Remove burner switch control knobs. 3. Open oven door and remove screws securing control panel. 4. Remove screws located on the right and left sides of the control panel. 5. Grasp control panel on the far left and right sides and gently pull the control panel out and down. 6. Remove infinite switch control knobs, infinite switches, indicator lights, rocker switches, and electronic control/clock (as necessary) and transfer to the new control panel. 7. Reverse procedure to reinstall control panel. Electronic Control 1. Remove control panel, see “Control Panel” procedure. 2. Remove screws securing electronic control bracket to control panel. 3. Label and disconnect terminal wiring from electronic control. 4. Reverse procedure to reinstall electronic control." Thanks and Good Luck Read More...