Customer Questions and Answers for Sealed Gas Burner Head by Whirlpool

Hello Susan. Check and make sure the burner is good and clean. If so, and it does not spark properly, you may need to replace the spark module. Hope this helps.

Hello Jodi! The burner grates used on your Maytag Range model MGR5751ADW is part number WP7518P464-60. The grates come one per package. The burners come only as a fully assembled part. You will need one WP3412D021-09 and three WP3412D024-09. Here is the information located from the manufacture regarding the removal and installation of the burners. Hope this helps! Sealed Burner 1. Turn off electrical power and gas to the range. 2. Disconnect gas and power from unit. 3. Remove grates. 4. Obtain Burner Wrench (removal and installation tool, P/N AP3854752, see picture below). 5. Place Burner Wrench on burner properly (the wrench is labeled for proper ignitor alignment). 6. Once the wrench is properly aligned on the burner, apply steady and even pressure while turning the wrench counterclockwise. Turn the burner no more than two inches to loosen. NOTE: Some minor crunching or grinding sounds may be heard. This is normal, but be careful not to chip the finish in visible areas. 7. Once loose, lift the burner straight up and out of the mounting hole. 8. Label and disconnect wire terminals from burner. 9. Remove screw and washer (securing burner support to main top) from the burner openings. 10. Replace and reassemble in reverse order.

Hello Jean. If the igniters are not working on the burners, you will need to test the igniters 74004053. Make sure they are not crack and read closed for continuity. If they are good, you will need to replace the spark module 8215557. Also, make sure the burners are good and clean and no moisture is present. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps.http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html

Hello Les! The burner head WP3412D024-09 should not need a new screw 7101P343-60 unless the old is stripped. Thanks.

Hello David! It seems that the original burner heads have been discontinued and redesigned to use part number WP3412D024-09. This burner head no longer requires a seal for the installation and your unit will use 4 of these. Thanks.

Hello Chris! We will need the type number located on the model number location plate. Thanks.