Jack July 25, 2011 for Model Number ED2GTQXKT04 How do you remove water line sprout to feed ice maker water? Got to replace sprout.
2 Answers Jack, Replacing a fill spout for an ice maker, is not a common problem, Most fill tube problems are due to a seaping water inlert valve and the tube freezes up and won't fill the ice maker. Most ice maker fill tubes require you to remove the fridger, so you can access the back of the unit. Disconnect the 1/4 in. fill tube from the grommet. The grommet and fill spout are a very tight"friction" fit, You'll need to pull the fitting out the back of the freezer wall, and force the grommet and spout into the opening, and mkae sure there is a good,tight seal to the back of the cabinet. Good Luck and Thanks. Read More...
Jay H. July 25, 2011 Whirlpool Ice Maker, part #628356. I have read by other's comments that one must remove three screws to remove the ice maker from the inside of the freezer compartment. I found the phillips head screw underneath and one hex head screw on the underside just behind the auger motor which I could remove with a nut driver. I can't find the third screw and the assembly will not come out. please help me find the third screw or offer complete instructions for dis-assembly of the ice maker from inside the freezer. Thanks.
1 Answer Hello Jay. There is two screws at the top of the icemaker, toward the front and back, and one under the bottom of the icemaker. You will need to remove all three screws to remove the icemaker. Hope this helps. Read More...
Joe July 25, 2011 for Model Number ARB9058CB Hello. Does the metal arm, im shutoff Part Number: AP4077996, fit into this bearing AP3131673? The arm on my machine seems to have broken off of something. It has a broken peice of plastic on it and it looks like the upper edge of this photo, but I can't find the rest of the peice on the ice tray to confirm. Thanks
1 Answer Hello Joe. Yes, the shut off arm goes inside the bearing WP628356 and the module of the icemaker. Hope this helps. Read More...
Dick R. June 08, 2011 for Model Number Kitchenaid model KBRA20ELWH00 Part no. 8170928 is what I ordered. On the package received it says 628356. Please tell me, how do I install this? It looks to be a simple press fit. However, I tried to remove the broken part with leverage, and it did not pop out. I am hesitant to apply too much pressure, as the parts are plastic and may be easily broken. Thanks!
1 Answer Hello Dick. You will need to remove the module and the stripper from the icemaker. Then there is a clip on the bearing that releases to remove from the mold assembly. Reinstall in reverse order. Hope this helps. Read More...