William R. September 01, 2012 for Model Number WU282 I have an old maytag dishwasher model wu282 -belt measures 26 5/8 long. Your part# AP4372892 is what length? Do I have the wrong part #? Please advise.
1 Answer Hello William! According to your mdoel number the belt 6-9021150 is the correct replacement used on your model WU282. Unfortunately, we do not have the length information available. Thanks! Read More...
Dominick R August 02, 2012 for Model Number Maytag wu203 Will drive belt part number AP4372892 fit Maytag Model number wu203?
Don G June 19, 2012 for Model Number maytag undercounter MAYTAG 6-9021150 DISHWASHER DRIVE BELT is 25 1/2 long my broken belt.. clear plastice 1/4" round.. the replacement is 25 1/2.. will this fit?
Lester April 29, 2012 for Model Number WU502 The clear plastic pummp drivebelt broke on my Maytag dishwasher Model WU 502. Putting the old one together to see how a new one would intstall, I can't see how to get the belt over the pulleys without loosening the motor so the belt can go over both pulleys. But I am afraid to take the clips off the motor because I would need to pull the motor back into place against the pressure of the re-installed belt. I don't know how that could be done without a special tool or having two people on the floor, one pulling on the motor and the other replacing the clips. This too seems difficult or impossible because of the restricted space, the backpressure necessary to overcome the resistance of the belt on both pulleys (motor and pump pulleys). Can you give me a clue on what I would have to do????
1 Answer Lester, It may be tough, depending on the installation and the clearance between the pulley(s) and the floor. The most common belt installation on your unit is: Leave the belt "dry", slip the belt onto the motor pulley, from underneath and hold it in position. Slip the belt onto the pump pulley from underneath and "roll" it onto the pulley, then lubricate the belt with the "Poly Lube" supplied with the belt. It'll be a tight fit, and may take a couple of attempts, but you'll get it on and be operating in no time. Good Luck and Thanks Read More...
Ayla H. August 23, 2011 for Model Number Maytag WU303 I have an old Maytag dishwasher, Model WU303. The pump drive belt broke and I'm looking for a replacement part. Problem is, all of the ones I've found are listed as 25 3/8" in length, but my broken belt is 27 1/2" (give or take 1/8") in length! The other specs; clear plastic, 1/4" diameter, match. A 25 3/8" belt couldn't possibly stretch that much, could it?? Can you please, please help me?? Feel free to write me directly. Thank you for any help, Ayla
1 Answer Hello Ayla! The belt supplied as the replacement part for your WU303 Maytag Dishwasher is 6-9021150. This belt measures 25 3/8" long and 1/4" diameter. This is the only belt listed for your product as the replacement and per the manufacture will work on your product. Perhaps the belt taken off the unit has expanded? Thanks. Read More...
Craig B. April 22, 2011 for Model Number WU601 I have a Matag Model: WU607, that I purchased in 1976. The pump drive belt just broke and when I did a search for it, it came up with this Whirlpool belt. Is this Whirlpool belt interchangeable with the old Matag belt?
1 Answer Hello Craig. Whrilpool is now the owner of Maytag. If you order a Maytag part, it will come as a Whirlpool. Hope this helps. Read More...