Larry April 17, 2019 for Model Number lse6700w1 I have a whirlpool dryer. I am replacing the front felt seal. In the video it tells you to clean the old adhesive before putting on the new seal. I want to know what I should use to clean off the old adhesive?
Rick October 01, 2016 for Model Number WED4750XQ0 I am replacing front bearing and seal with 279264 kit on whirlpool dryer ,original bearing is not glued, your video says use pins only to attach bearing, instructions say to glue bearing. Which is correct?
1 Answer Rick, You will want to use the adhesive as stated in the instructions that come with the part. Read More...
Renee August 03, 2016 for Model Number LER46434JQ1 I replaced the front felt drum seal and 1- I can't get the larger piece to folded over and 2-the drum is now so tight I can't turn it by hand. What am I doing wrong?
1 Answer Hello Renee. You do not need to fold the large piece over. You need to follow the instructions and the video on the parts page step by step. It sounds like your binding the drum by folding that large piece over. Read More...
Rebecca March 18, 2016 for Model Number LER5644JQ2 After successfully replacing the belt and drying one load of clothes, the front seal won't stay in place (peeks out when door is open). When we tried to put it back on it seems stretched out and doesn't lay flush on the rim. Does this mean it needs replacing? Also, why do you recommend using adhesive on the replacement if the original seal isn't glued down? Thank you!
1 Answer Rebecca, Yes with the seal being stretched out then it would be best to replace it. As for the adhesive, it may not be required because this is front bearing and seal kit is a universal kit. There will be instructions on how to install and if you need to use adhesive. Read More...
Ed December 06, 2014 for Model Number LGR7646AN0 When I push the start dryer turns dryer heats replaced front felt seal but dryer makes this loud scraping noise.
1 Answer Hello Ed. You need to check and see if the rollers are bad on the unit and need to be replaced. Read More...
Willy August 24, 2014 Inglis dryer Liberator Plus model dryer made a banging noise when the start button was pressed to start the dryer.no longer working
1 Answer Willy, You will first want to check the belt on the unit to make sure that it did not break, the other thing would most likely be something either caught in the blower wheel or a bad motor. Read More...
J November 11, 2013 My dryer is a whirlpool and when I push the start button it comes on and then I open the door and when I close the door and push the start button again it makes noise and it won`t spin, do you know what part it could be?
Cindy April 09, 2011 for Model Number REX5634KQ0 I need the bearing that makes the tub turn. What is the name of this?
1 Answer Hello Cindy! The dryer glides on the front bearing 279264 and rear felt seals 239087. There are also rollers 349241T that support the drum in turning. Hope this helps! Read More...
1 Answer Hello, if you are needing the front drum bearing for model number (LE5750XKW0). You will want to order part number WP3394508. Hope this helps! Read More...