Customer Questions and Answers for Oven Door Handle by Whirlpool

Hello Rhea, the model number given is for a white appliance, the manufacturer only lists this model as being white in color, with no other color options, the white oven door handle is part WP2411F013-71.

Susan, The part number for the oven door handle would be WP74011778.

Rick, In order to tighten the handle on this unit you will need to remove the door and disassemble it.

Hello Jeanne. You will need to order the screws WP74006515 needed.

Mark, The model listed is not valid or is not complete. To properly assist you we will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx

Hello Dennis! The part number WP74011778 does not include the screws, the screws for this handle is part number WP74006515. Thanks!

Hello Chance, To change the handle in an oven door, you will need to determine how to remove the door on the model number you are working on. If you open the door to the first stopping point, some oven doors will lift off the unit in this position. On other models, you will see clips on the back of the hinge toward the opening where the hinge enters the range. If yours is like this, you will open the door all the way open, then pull the clips down until they stop and lock in place. Then close the door to the stopping point and lift the door off the range. If you door does not lift off, and it does not have the clips, then you will open the door all the way open. You will see a hole in the hinge at the bottom of the door. You will insert a pin or nail into that hole and close the door to the stopping point. Then you can lift the door off the unit. Once the door is removed, you will lay it on a soft surface and disassemble the door. Pay attention and make notes if needed for reassembly of the oven door. Once you have replaced the door handle WP74011778, you will reinstall the oven door back onto the range in reverse order of the way you removed it.

Judy, Yes, the screws are available seprately WP74006515, You didn't supply a model number but here are the basic instructions for dismantling the door. " 1. Remove oven door, see "Oven Door(s)-Door Removal" procedure. 2. Remove screws securing doorframe to liner located at the bottom. 3. Remove side screws securing doorframe to door liner. 4. Remove screws securing door trim at the top. 5. Slide doorframe and glass off liner from the bottom. 6. Remove screws securing door handle to door trim / liner." Thanks

Hello David. 1. Open oven door and place door hinge locking device into lock position. 2. Place oven door in first stop position, then grasp both sides and lift up off the hinges. 3. Reverse procedure to reinstall oven door. Hope this helps.

Hello Robert! You will need to remove the door from the oven. Disassemble the door to access the screws for the door handle. Reinstall in the reverse order. Hope this helps! Thanks!