Customer Questions and Answers for Pantry Lid Assembly by Whirlpool

Jessica, The part number for the pantry lid on your unit will be W10827914.

Hello Anat, we will need the correct model number in order to locate the correct part for your unit. Thanks!

John, Once you remove power to the refrigerator, remove the clear plastic light cover, Look up to the ceiling of the refrigerator,. You should see two(2) slots in the ceiling panel along the back edge of the control panel housing, about 2 inches in from the corners. Insert a flat blade screwdriver into the slot, until you feel the hidden tab inside the slot. press in, or towards the back of the housing, and pull down on the rear corner of the housing(carefully). Repeat the process for the other corner. The front of the housing is held in position by three stationary tabs across the front edge, so you'll need to pivot the control housing down and out of the slots, and be careful not to damage the wiring harness.

Hello Rae, W10827914 is the deli cover listed by the manufacturer for the model provided.

Mark, You will need to replace the left side Endcap W10874836 / W10874836 . It's not too difficult a repair to make, but you will need to remove, it'll be easier if you remove the crisper drawers, and shelves,and deli drawer, once you remove all that you'll need to remove two(2) screws and remove the end cap, reverse the procedure and you're done.

Roger, The "pins" you're refrring to are actually part of the Pantry Drawer Support Track(s) WP12656105/8171058 Lft, and WP12656018/8208282 Rt . Watch the video attached to the WP12656105 in the parts order screen, you'll have a better idea and understanding of the deli drawer and door operation and repair. Thanks

Hello Krishna! Yes, the pantry lid, part number WP67005930, is the correct replacement for your model and includes the front clear window. Thanks!

Rena, you'll need the right side end cap part number W10874836. Thanks.

Hello Jackie. Yes part# WP67005930 is the correct deli lid for your model.

Sharon, It's an easy repair, but you'll need to go by the local hardware store or home improvement center and purchase 3 to 6 nylon or plastic washers/spacers. You'll need to remove the shelf, drawer, and lid from the assembly. Remove the three screws that secure the WP12656105 drawer support track to the wall of the refrigerator. Slide one washer over each of the screws(on the inside of the assembly), and reinstall the track support( the washer should be between the refrigerator wall and the track support) This will move the support closer to the hinge and the post and get a tighter fit, and the lid will fit tighter to the actuator. You only need to service the one side.