Customer Questions and Answers for Microwave Door Handle by Whirlpool

harry, call our office at 1-977-477-7278, they will be ale to assist you and answer any questions you may have.

Brian, The correct door handle to order, for the model number you supplied is 5304440323 / 5304440323 Microwave Black Door Handle. The part is in stock and available at this time. To order, enter AppliancePartsPros.com into your browser, When the home page loads up enter either of the above part numbers in the "Find Your Parts" header and click search. When the parts photo and part information appear, click on the "Add to Cart" header and follow the instructions to order the part. Thanks,

Jessica, Here is a generic video on replacing the door handle on a microwave. This is not specific your unit but will help you to replace it. https://www.youtube.com/watch?v=sDmFpLSyiDo&t=5s

Evan, The door handle that you have listed W10246505 is a black handle. The handle that your unit would call for is stainless in color and is part number W10272107.

Hello Bill. 1. Unplug microwave oven or disconnect power. 2. Open the microwave oven door. 3. Pry the choke cover away from the top door pin, and remove the top pin from the pivot bracket. Lift the door off the bottom bracket, and remove it. 4. Place the oven door front side down on a padded surface. 5. Remove the choke screws from the door frame. 6. Starting at the top right corner, pry the choke cover out with a putty knife, and unsnap it from the choke. Only remove the top, bottom and right sides of the choke cover at this time. You will remove the handle end of the choke cover later. 7. Starting at the top edge of the door near the center and working clockwise, use a putty knife, and pry the latching tabs of the choke out of the door frame slots. Lift the choke as you release the tabs so they do not snap back into the slots. NOTE: When you reach the handle side of door, pull both the choke and the choke cover away from the door frame, and then separate the two components. 8. To remove the door switch actuators from the choke, remove the screw from each actuator. REASSEMBLY NOTE: When you reinstall the door on the oven, insert the top pin into the pivot bracket and press down on the pin until it snaps into place. Hope this helps.

Hi Crystal. On the inside of the door, surrounding the glass is a black frame. This is called a "choke". Very carefully take a thin flst blade screwdriver adn remove this whole part. The screws should be accessible behind the door latch springs. Thank you.