Eddie February 23, 2013 for Model Number 110.28722700 My Kenmore 700 washer, which is about 5 years old, will not spin on every cycle. I checked the pump, clutch & motor coupling and they were fine. I changed the lid switch because it was bad. It still did the same thing. I changed the timer.because it sounded like it was not moving through all the cycles; but that was not the problem either. I can hear the motor humming like it is trying to go into the spin cycle but then it stops, almost like it's overheating. It does the same thing when there are no clothes in the machine. All I have left are the transmission and motor. Do you have any suggestions?
1 Answer Hello Eddie. Turn the motor by hand and make sure nothing is binding. If not, you will need to order and replace the motor in the unit. Read More...
Mike February 03, 2013 for Model Number LSN2000PG2 My Motor started to smoke & stopped. I took apart the washer. Took off the pump. It turned with a little resistance but seemed okay. I turned shaft on motor it turn free in both directions. The tub spun one way & the shaft in tub went back & forth the other. I put the washer back together. It ran with out any clothes for a full cycle. The water both in & out was fine. I ran another cycle with some clothes. It Stopped in the last spin. After about 10 minutes it started up spun out the water. I believe it was off on motor overload. This unit is 8 years old. When it was uder warranty we have a technition over because the was a squeek a the end of some spin cycles. Is there anything else that could cause the motor to do this. Could the squeek cause anything. I would want to order the motor if it is only this. I think the # is 8529935. Thank you for your help; Mike
1 Answer Hello Mike. No, if the bearings are good, and if the motor does this again, you will need to order and replace the motor in the unit. Read More...
Marc Alejo December 22, 2012 for Model Number GSQ9669LW1 A repair man came to my home and installed motor number 8541504 but I had motor number 8529935. Now the machine has low and ex low speed but no High. My original motor had three speeds. WRONG motor?
Jim June 21, 2012 for Model Number 110.24872300 my model number is for the washer ,kenmore. my problem is,i belive the motor. washer fills but no drain ,no agatate,no wash. motor hums like its trying. i remove the water pump from one side of motor,then i jumpered the lid switch and pluged the machine in,then set to spin cycle,motor again hums,i reach down and helped the shaft to spin on motor. it takes off like normal. motor seems good.just needs a boost to start? why is this. motor seems good.
1 Answer Jim, Check for 120 VAC across the yellow and black wire on the motor, while it's humming. at the yellow Improper volyage would indicate a faulty timer WP8539991 or low voltage at the outlet. If the voltage is correct, then you'd have a bad motor winding WP8529935. Thanks Read More...
Mark April 23, 2012 My kenmore series 80 washer is leaving my clothes very wet after spin cycle. What could cause this?
1 Answer Hello Mark. If the clutch is bad on the unit and is not getting to a full spin, it will cause the issue you are having. Also, a bad motor coupling or pump can be the issue. Read More...
Anthony March 16, 2012 for Model Number whool pool washer Hi. I have a whirlpool washer and last night my wife turned it on and it went to fill and when it was supposed to go to the next step to wash, it blew a fuse but only in agatate. The spin works but not wash. Is it the motor or the capacitor burned out to make it just blow a fuse? How can I test this motor with my meter for forward and reverse. Is it a switch in the motor? my motor is a Number 8529935 washer motor thaks anthony muro cedargrove NJ
1 Answer Hello Anthony. Sounds like the motor or the harness has shorted. It could also be a set of points in the timer that has stuck. We can look up more specific information for you with a model number. Have a great day! Read More...
Bob December 03, 2011 for Model Number Kenmore Washing Machine Model 110.23832100 Is the motor Part Number: AP3125983 a reversing motor? One direction for agitate the other direction for spin cycle.
1 Answer Hello Bob. Yes, the motor WP8529935 goes in one direction for spin and the other direction for agitate. Hope this helps. Read More...
Buster September 21, 2011 for Model Number Unknown Is this part (AP3125983) a '2-Speed' or '3-Speed' Motor?