Shirley June 27, 2012 for Model Number 110.87878100 Changing lp gas to natural; What parts do I need? Orifice and regulator, or just orific and change brass fitting on top of regulator? And do you have the part numbers?
1 Answer Shirley, you will need the nat gas orifice WP234826, the nat gas limiter WP694424, nat gas spring WP694422, and the nat gas regulator WP694423. Thanks! Read More...
Len December 28, 2011 for Model Number wgd9600tw1 Hello again. Changing my 2008 whirlpool duet from lp to ng;I removed all lp parts; installed brass ng orifice, spring part # ap3081255, then white plastic regulator # ap3081254, how far down do I screw it 3 turns ? I screwed it down snug on spring then installed cap # ap3135346 , dryer runs great BUT! sounds like jet engine ? PS I dont have meter.....
1 Answer Len, There are no adjustments to make, or specific turns on the cap. As long as you've installed the Nat gas valve components(orifice,cap, spring, regulator) and you have 3.5 WCI gas pressure at the gas valve, you're set and done. You'll need to adjust the fuel air mixture at the air shutter on the burner tube( usually 1/2 to 3/4 open) you should be fine. You may need to have the gas company or a servicer out to test the pressure at the gas valve. Good Luck and Thanks Read More...
Roger March 26, 2011 for Model Number NGD4500VQC My dryer will light will have a flame for 6 minutes then it shuts off I'll start again it will light then stop.What part do I need to replace I was told the coil were still good.
1 Answer Hello Roger. Here are a couple of things that you might want to try. The easiest test to do for the condition you discribed is to remove and clear the exhaust vent. It may be restricted with excess lint which restricts the discharge of air. This condition will cause the dryers burner to shutoff do to overheating. If the dryer will run normally with the vent removed, either clearing the vent tube and checking the flapper door on the vent hood should correct the problem. Another place to check is the fan blower cage. Make sure it is clear of lint and debris. If everything is clear then it sounds like the coils need to be replaced. The part number for the coil kit for your model is 279834. Hope this helps. Read More...