Jennifer September 16, 2019 for Model Number MHW8200FW0 F03 and E01 codes are blinking when washing machine finishes. Seems to reset and then I can do another load. Loads seem to be finishing quicker than usual though.
1 Answer Hello Jennifer, the code refers to the water level sensor not to able to correctly read the tub's water level. The water level pressure switch is located under the top in the upper right side panel area, the airline hose from it goes to a fitting on the lower side of the outer tub. Check for any type of blockage/suds/residue . Read More...
Jose December 05, 2018 for Model Number WFW8740DW0 i have a front washer won't complete the spin cycle with normal or heavy load only with low load.
1 Answer Jose, If the unit will not spin in the normal and heavy load but will with the low load then this would most likely be a motor control board or main control board issue. Read More...
Dick December 29, 2016 for Model Number wfw95heduo I unplugged the washer because the pump continued to run. When plugged back in, the pump continues to run. Nothing else happens. No lights come on at the controls.
1 Answer Hello Dick, This is most likely an issue with the pressure switch WPW10448876 or the main control board W11032117. You can pull the tech sheet from the unit to see if you can pull fault codes and run tests. Read More...