James January 18, 2026 for Model Number WTW4800XQ4 I got replacement rods for this whirlpool machine. I installed and it worked fine. But now I notice that the tub is sitting too low In the machine. Are the rods y sent too long
1 Answer James, thanks for the question. Based on the model number provided, these are the correct suspension rods for your machine. Read More...
J. August 25, 2025 for Model Number Whirlpool 8MWTW1925 I need to replace the suspension on my Washer, Whirlpool Top load 19kg, the Manual says the part number is W10257088, that shows discontinued, what would be the new part number?
1 Answer Hello J., thank you for contacting AppliancePartsPros.com The substitute part # for suspension rods W10257088 is the suspension rod kit W10780048 W10780048. Read More...
Mike August 25, 2024 for Model Number 110.22352511. I have a Kenmore washer and model number is 110.22352511. It shakes and vibrate when it is spinning. What do you think it could be?
1 Answer Mike, 1. This could be because the machine is not level and firmly on the floor. 2. The floor is weak. 3. The balance ring is damaged. 4. Suspension Rod Springs are weak. 5. Tub bearing issues Read More...
William December 21, 2023 for Model Number 1cwtw45454w1 what suspension rod kit is available for this washer
1 Answer William, unfortunately, the model provided is not showing as a valid model within our available database. If the model number could be verified from the model/serial tag and provided in a new question, this may allow the most accurate information to be presented. Read More...
Carlos November 18, 2023 for Model Number NTW4605EW0 I purchased a suspension rod kit (W10780048) for my washer. The part # i received matched what was ordered but, The new parts are shorter than the ones i am replacing? Original parts are 25" in length. Can you confirm the box was labeled correctly?
Dave November 05, 2023 for Model Number Whirlpool WTS6200VWO What suspension rod kit works with this washing machine? Did I miss where the parts catalog is shown on your website?
1 Answer Dave, The part number for the suspension rod kit for this unit will be W10780048. Read More...
Hk October 25, 2023 for Model Number ntw4651bq1 Hello, I am looking for a suspension road for ntw4651bq1, I see Suspension Rod Kit W10780048 / AP5971398 part number but do not see the length of the road, online it is showing 23.6 but rode from my washer is 25.25 or something, Can you please share the accurate part and the length of the road
1 Answer HK, the manufacturer shows the suspension rod kit W10780045 as being used with the model number provided. Unfortunately, the manufacturer does not provide the exact measurement of the rods. Read More...
Steve August 25, 2023 for Model Number ATW4675YQ1 Will suspension rod kit W10780045 work instead of W10780048
Ronnie June 29, 2023 I replaced the suspension rods and it worked for a short time but then it started banging again. Is there another part that I need to fix this problem?
1 Answer Hello Ronnie, check if the inner tub is tipped to one side slightly, it is secured on the drive block by a spanner nut. If off-center the washer will be unbalanced in spin and gets worse with a clothes load. Open the washer top , remove the outer tub top cover and rotate the inner tub and watch the gap between it and the inside of the outer tub. Read More...