Customer Questions and Answers for Water Inlet Valve Assembly by Whirlpool

Hello Rene. Based on the information you provided, you will need to order and replace the water valve on the unit. Thank you.

Hello Mac. You will need to remove the control panel to access the valve. It has screws holding it into place. You will need to raise the top of the washer to remove the clamps from the hoses attached to the valve. Reassemble in reverse order. Hope this helped!

KGill, You will want to check the water valve screens to make sure that they are not plugged up with debris but it sounds likely that the issue will be a bad water valve.

Hello Charlie. Test for power to the water valve. If there is power there and no water comes in, You will need to order and replace the valve on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html

Hello Vinny, You should pull the tech sheet from the inside form the inside of the front panel and run the diagnostic test mode. This will enable you to pull the fault codes which will point you in the correct direction for a proper diagnosis/repair. ACTIVATION OF AUTOMATIC DIAGNOSTIC TEST MODE 1. Be sure the washer is in standby mode (plugged in with all indicators off; or with only the Clothes Clean or Done indicator on). 2. Select any one button (except POWER and START/PAUSE) and follow the steps below, using the same button: a. Press/hold 3 seconds. b. Release for 3 seconds. c. Press/hold 3 seconds. d. Release for 3 seconds. e. Press/hold 3 seconds. If this test mode has been entered successfully, all indicators on the console are illuminated for 5 seconds with 88 showing in the Estimated Time Remaining two-digit display. If indicators do not display as described above, the press/hold/release procedure above may not have been performed within the time frame necessary for successful entry. Repeat step 2 to ensure this was not the cause. 3. The test sequence continues by checking for saved fault codes: If there are saved fault codes, see Diagnostic: Saved Fault Codes, page 2 of tech sheet. If there are no saved fault codes, all indicators on the console will momentarily turn off, then turn back on with 88 displayed. After 5 seconds, the Automatic test, below, begins. If this is the case there is a good chance of a harness issue or an issue with the control W10763748.

Matt, The valve assembly (blue piping) is not available as a separate part and will have to get the water valve assembly for your unit.

Matt, With this issue you would need a new water valve which is part number W10364988.

Hello James. You will need to order and replace the water valve on the unit.

Mike, The LF represents a long fill so it would be likely that the water valve will be the issue with the unit.

Hello Smokey. You will need to replace the bleach dispenser WPW10161865 on the unit.