George May 30, 2014 for Model Number mah5500bww/serial:b2949238et Tub fills w/ water when off. Is this the correct part to replace to fix? Water Inlet Valve 22003245
1 Answer Hello George. You need to order WP22003834 based on the model and serial number you provided. Read More...
Ray April 23, 2014 for Model Number mah7500awq During the wash cycle water pours out of the front. I mean a bunch pours out.
1 Answer Hello Ray. You need to check and see if there is any tears in the boot 12002533 and if you need to replace the boot on the unit. Read More...
John April 22, 2014 for Model Number MAH5500BWW Serial # A5964160CV. After the washer shuts off water still continuously leaks into the washer. To the point that it fills and forces water out. I am guessing the water valve needs to be replaced, but there are two options available. Which part number is appropriate for my serial #?
1 Answer John, the valve listed for your model and series is part number WP22003834. Thanks! Read More...
Barbara March 20, 2014 for Model Number MAH5500bww S/N 74976585ZW After the wash is done and removed, if I check the drum later there about 2-3 cups of water that has leaked into it. Would the water inlet valve be leaking and the cause of the problem. Do not know the series #. What part number would be needed. Thank you
1 Answer Barbara, The water valve leaking would cause the unit to have water in it after sitting for a little bit. The part number for the water valve for your series is WP22003245. Read More...
Robin March 12, 2014 for Model Number MAH5500BWW S/N 74 Water just trickles into the detergent dispenser when starting the cycle and I'm not getting an error code. I have full water pressure coming into the Bleach & Fabric Softener dispenser's. There's no continuity on the Solenoid (located in the middle of the Valve). Therefore, I need to know what Ohm reading I should get on the Solenoid using a Digital Multimeter (include scale setting either 200, 2k, 20k, 200k or 2,000k).
1 Answer Hello Robin. Check and see if the screens in the hose and valve are clogged. If not, you will need to order and replace the water valve on the unit. Read More...
Kyle October 08, 2013 for Model Number MAH5500BWW As soon as the machine is turned on, water starts spewing out of the middle, off white colored part of the dispenser valve (the part in the middle that feeds from the detergent compartment, with the prongs and clips on top). Is there a way to repair this, or would I have to buy a new part, or is it possible that it is another issue?
1 Answer Hello Kyle. If you can stop the water from entering the machine by turning off the timer or unplugging the unit, you will need to look for a bad pressure hose or replace the pressure switch. If the only way to shut off the water is at the shut off for the water hoses, you will need to replace the water valve in the unit. Read More...
Lloyd September 07, 2013 for Model Number MAH5500BWW The washer does not fill and does not give a NF error. It sounds like it starts to fill an stops before much water gets in, maybe a second or less. I can't find any thing that looks like a fill level sensor. Is it part of the fill valve assembly? Thanks Lloyd
1 Answer Hello Lloyd. Make sure the filter screens in the valve are not clogged. There are 3 different pressure switches and the serial number determines which one you need to order. Read More...
Deb C. July 31, 2013 for Model Number MAH5500BWW Serial Number is A9705247EN The cold water will not fill. Also noticed a slow leak at the valve connection on the machine. Was told I needed a new valve. Is this correct? Which of the two valves do I need?
Murray May 27, 2013 for Model Number MAH5500BWW hi .have a maytag Neptune F/L washer ,model MAH5500bww it has a water valve # 22003245 ,the water fills to high, it does eventually stop filling and tumbles normally , but way too much water comes in before it stops filling, could it be the water valve? thanks, Murray
1 Answer Murray, You will want to check the pressure hose to make sure that it is not kinked or clogged. Also check the air dome is not clogged. If kinked or clogged you will want to clear or unkink. If this checks ok then the most probable cause would be the pressure switch. Read More...
Varonica February 20, 2013 for Model Number MAH5500BWW My Washer has started giving me a NF code when washing on the cold cycle. It act as if it is trying to fill with water but does nothing (there is a buzzing as it does this). Research suggest we look into replacing the water inlet valve and we want to make sure that we order the correct part. The model is MAH5500BWW and the serial number is 89953424AL . We are also looking to replace seal around the door as it has mold on it that will not come off no matter how much cleaning. Thank you,
1 Answer Hello Varonica. Check and make sure there is no clogs in the screens and if not, you will need to order and replace the water valve in the unit. Read More...