Washer Cold Blower Wheel Fan Blade Parts

• Spins slowly
• Pumps but will not spin
• Will not agitate

My Maytag washer make a loud screech when the washer tub needed to be stopped by the brake. Last year, I had replaced the suspension springs, the snubber ring, the drive belt and the drain pump. Those repairs worked fine, but a few weeks later, the screeching noise started. So I figured it was the brake system. I thought it would be better to replace the brake rotor and stator together as a set since I was going to disassemble both and they were 18 years old anyway. I decided to replace the... Read more

Replaced thr motor pulley and transmission pulliey and belt. Read more

Replaced thr motor pulley and transmission pulliey and belt. Read more

The belt/Idler kit arrived next day after placing the order. The included directions were very clear with an exploded diagram. Four bolts remove the motor/pump assembly from the machine, three clips release the pump from the motor, then four small nuts remove the support brace from the motor to get access to the pulley and lever. Reverse order to re-assemble. The idler/pulley was in good condition. However, the kit is just a few $ more and replacement was only few extra steps. The worn belt... Read more

Upon removal of the lower inspection panel on the front of the machine, my 20 year old son thought the motor was bad by the smell. But he did discover what turned out to be the belt tensioner pulley laying inside the machine. After he pronounced it dead, without a thought to the idler pulley, I looked at the machine and determined the lack of movement was due to the idler pulley having "fallen" off the shaft by looking at the illustrated parts break down provided on this website. Ordered the... Read more

I pulled the unit away from the wall and noticed black dust on the floor. Unplugged the unit, turned off the water. Removed back panel (about 10 screws with Torx heads) and noticed the belt was off, the drive pulley was loose and wobbling on the shaft, black dust all over the inside. Belt was worn along one side. Some grooves/damage in the outer drum casing around the pulley where it appeared the belt had rubbed. Removed the lower crossbar (2 more screws) to get better access to the drive... Read more

Found the belt was thrown off. Reinstalled the belt and when doing so felt that the pulley was wobbling on the barrel shaft. Took the pulley off and noticed the inside of the pulley was worn badly and needed to be replaced. When received the new pulley and belt easily installed and was working like new. Read more

I replaced the drum bearing in the back and also the nylon sliders in the front. It rook some time but was not difficult. I took some extra time to thoroughly clean all the lint from the inside. Read more

Acualy sounded and looked major but with a littel help with you tube the job only took 30 minutes. 3 bolts for the water pump pulley broken pulley poped off new one klick into place simple belt install good to go. Parts saved me $40 and where here in only 2 days. I couldnt be happyer. Read more

Replaced the shaft & mode shifter assembly. Also replaced the pulley as it had taken some damage from the wobbling clutch dog. And replaced the tub seal since it's normally inaccessible with the shaft in place. This is an advanced repair that took a lot of time. Removing the tub nut took a 1 11/16" socket and a 700 ft-lb impact wrench and I had to hammer on the nut for several minutes to break it free of the tub. Disassembly of the washer is complete, and requires a lot of space for... Read more

After disconnecting power, removed rear access panel. belt was already off. Removed bolt washers at center of pulley, removed pulley.installed new pulley on to drum shaft. Installed washers and bolt with blue thread locker applied to threads. Installed new belt. Reinstalled rear access panel. Reconnect to power. good to go! Read more