417-9781-2704 Parts

Best Seller

Genuine Frigidaire part

Tub Seal

By: Frigidaire

Part Number: 5303279394

The Tub Seal is an OEM part for Frigidaire washing machines. It is designed to create a water-tight seal between the washing machine tub and the transmission or drive system. This seal prevents water from leaking out during the operation of the washer and protects the mechanical components from water damage.

Symptoms of a failing tub seal include:

Water leaking from the underside of the washing machine.
Increased moisture or puddles forming under the machine during use.
A musty or moldy smell, indicating that water has been seeping and not properly drying.

Causes of a bad tub seal can include aging and wear over time, exposure to harsh detergents that degrade the material of the seal, or mechanical stress from unbalanced loads that can cause the seal to fail. It's important to address these issues promptly to prevent further damage to the washing machine.

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

This part fixes the following symptoms

Leaking

Do-It-Yourself Stories from Customers like You Noisey bearing on spin cycle Neal G. • Klamath Falls , OR • February 14, 2016

I replaced the spin bearing, tub seal, washer and drive belt since I had it all apart. The video was extremely helpful...I would have tore the whole thing apart trying to figure out how the agitator came off....but it was very simple. Read more

Best Seller

Genuine Frigidaire part

Idler Pulley

4.8 (31)

By: Frigidaire

Part Number: 131862900

The Idler Pulley is an OEM part for Frigidaire dryers. It helps guide and maintain tension on the dryer drum belt, ensuring the drum rotates smoothly during the drying cycle.

Over time, the idler pulley can wear out due to friction and regular use, or it may become damaged from excessive strain or misalignment. If the idler pulley fails, the dryer drum may not rotate properly, leading to inefficient drying or a complete inability to dry clothes.

Symptoms of a bad Idler Pulley include:

Squeaking or squealing noises during operation
The drum not rotating or rotating unevenly
The belt appearing loose or slipping off the drum

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

This part fixes the following symptoms

Burning smell

Do-It-Yourself Stories from Customers like You Noisey bearing on spin cycle Neal G. • Klamath Falls , OR • February 14, 2016

Best Seller

Genuine Frigidaire part

Agitator Hub

5.0 (9)

By: Frigidaire

Part Number: 134418700

The Agitator Hub is an OEM part for Frigidaire washing machines. It connects the agitator to the drive shaft, enabling the agitator to rotate and move clothes effectively during the wash cycle.

Causes of a bad agitator hub can include wear and tear from frequent use, exposure to harsh detergents or hard water, or damage from overloading the washer.

Symptoms of a bad agitator hub include:

Agitator not moving or rotating properly
Loud noises or grinding sounds during the wash cycle
Clothes not being cleaned effectively
The washer shaking or vibrating excessively

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

Do-It-Yourself Stories from Customers like You The agitator was not working John H. • Auburn , NY • October 11, 2016

The agitator stopped functioning and there was a squeaking sound occurring in agitation mode. I found that if I cranked down on the agitator cap, screwing in as hard as I could, the agitator would work briefly, then the cap would loosen and agitator stop moving. I removed the agitator cap, along with which came the agitator stud cap and a rubber washer/seal which was jammed up into the underside of the cap. I lifted out the agitator from the drum and inspected it and the hub best I could.... Read more

Genuine Frigidaire part

Agitator

4.9 (7)

By: Frigidaire

Part Number: 3204401

This agitator is a genuine Frigidaire part, sold individually. This agitator can be used as a replacement part for a washing machine or a washer/dryer combination appliance. This part rotates within the tub of the washing machine so that clothes and other items are tumbled around and fully cleaned.If an agitator has been subject to damage at some point in the standard lifespan of a washing machine, symptoms of damage will manifest in the form of a washing machine that will not agitate in a normal laundry cycle. If this is occurring, the agitator should be inspected for visible signs of damage, including punctures, scrapes, tears, and erosion to the material that could preclude it from serving its function. If the agitator seems damaged upon assessment, it should be removed and replaced with this genuine OEM replacement part before using the washing machine again.This is an OEM part sourced directly from the manufacturer. It is sold individually. This agitator is compatible with the following appliance brands: Frigidaire, Kenmore, Gibson, and Kelvinator.

Do-It-Yourself Stories from Customers like You Washer agitator and hub broken Michael A. • Fayetteville , AR • July 18, 2015

I own several apartments with same washer/dryer combo. A couple months ago, one of my washers stopped agitating. I hired an Appliance Repair Company. They charged my $95 for agitator, $65 for hub and $120 for service call, plus tax for a total of $310. Oh, and it took them FOUR WEEKS to get the part in and fix my washer!. Something to do with "Frigidaire shipping issues". Last week I had another unit break with same problem. Ordered parts from AppliancePartsPros.com for $80, parts arrived... Read more

Genuine Frigidaire part

Trunnion (Washer Inner Tub Hub)

4.7 (6)

By: Frigidaire

Part Number: 131545101

The trunnion is the hub that mounts the washer's inner tub to the drive shaft. Replacing a worn hub restores a solid, centered connection so the basket spins smoothly without wobble, slip, or grinding. What it does:

Secures and centers the spin basket on the drive shaft for balanced rotation
Transfers drive torque to the inner tub during spin
Helps maintain basket alignment to reduce vibration
Typical symptoms of failure: loose/wobbly tub, scraping or grinding noises, poor or no spin, frequent out-of-balance events

What's included:

1 trunnion

Install notes:

Disconnect power and water before service; wear gloves and eye protection
Access the hub by removing top/access parts, then the agitator/wash plate and inner-tub fasteners
Clean the shaft and mating surfaces; seat the new trunnion fully and tighten fasteners evenly in a crisscross pattern
Inspect related parts (tub seal, bolts, bearing) while open and replace if worn; run a short test cycle to ensure smooth spin

Do-It-Yourself Stories from Customers like You Leaking washer tub Hugh S. • Miami , FL • June 25, 2016

The seal at the bottom of the tub had started to fail. On large loads water would leak so I ordered a new one rubber seal. Getting the trunnion off the transmission shaft was hard as it was calcified and corroded. I used a wire brush to get some of it off and then used a lot of WD-40. The bolt holding the trunnion plate on sheared off when I tried to remove it on one side and the other came out ok (the bolt hole through the trunnion is not threaded so it should slide out once the plate is off... Read more

Genuine Frigidaire part

Cap

5.0 (2)

By: Frigidaire

Part Number: 3204395

Do-It-Yourself Stories from Customers like You The agitator was not working John H. • Auburn , NY • October 11, 2016

Genuine Frigidaire part

Bleach Dispenser

5.0 (1)

By: Frigidaire

Part Number: 3204394

Do-It-Yourself Stories from Customers like You Missing bleach dispenser. Jim W. • Ardmore , OK • May 12, 2020

Ordered part. Read more

Genuine Frigidaire part

Transmission Assy

5.0 (1)

By: Frigidaire

Part Number: 134735700

Do-It-Yourself Stories from Customers like You Frigidaire laundry center not agitating goes through whole wash process including spin cycle no agitation Keith Y. • Murrieta , CA • February 19, 2016

Replaced transmission. If you have a laundry center like me, you don't have alot of space. Replacing the parts want difficult. Just limited space made it harder. Also couldn't find a removal video for one of these but using a video for a frigidaire stand alone washer ouput me in the ball park and figured it out from there. Appliance parts pros had the best process too! Read more

Genuine Frigidaire part

Power Resistor

4.0 (1)

By: Frigidaire

Part Number: 134446800

Do-It-Yourself Stories from Customers like You Dryer timer would not advance in automatic dry mode worked fine in timed mode Michael S. • Bear , DE • February 05, 2016

Replaced the power resistor on the timer assembly. Solved the problem. Read more

Genuine Frigidaire part

Water Inlet Valve (Replacement), 1-Pack

5.0 (2)

By: Frigidaire

Part Number: 134892500

This water inlet valve controls water flow to the refrigerator's dispenser and ice maker, restoring proper filling and preventing unwanted leaks or running water when replaced. Designed as a direct-fit replacement for the factory valve. What it does

Opens and closes the water supply to the ice maker and dispenser when activated
Stops water flow to prevent continuous running or leaking from the dispenser
Restores proper water filling if the ice maker or dispenser is not dispensing or filling
Prevents intermittent or no-water symptoms caused by a failed valve

What's included

One water inlet valve

Install notes

Turn off electrical power and shut off the water supply before installing
Install with basic hand tools; verify inlet/outlet fittings match your appliance
Inspect water lines and connections for damage and tighten fittings to prevent leaks

Do-It-Yourself Stories from Customers like You Water leaking Michael S. • San Carlos , CA • July 30, 2021

Replacement part order and replaced. Read more

Genuine Frigidaire part

Guide Clip

4.9 (9)

By: Frigidaire

Part Number: 5303281074

Do-It-Yourself Stories from Customers like You Nothing worked Roger D. • Lengby , MN • December 15, 2015

Replaced the fuse by the heating element Read more

Genuine Frigidaire part

Transmission Pulley

By: Frigidaire

Part Number: 131498301

Genuine Frigidaire part

Switch-Temp

By: Frigidaire

Part Number: 134192400

Genuine Frigidaire part

End Cap

5.0 (1)

By: Frigidaire

Part Number: 131288211

White. Right hand side

Do-It-Yourself Stories from Customers like You Washer wouldn't run but as dryer did it obviously wasn't a circuit breaker E James W. • Wilmington , NC • September 29, 2014

First attempt was to replace the door latch mechanism...didn't fix it. Kept researching and the washer control knob had been hard to turn so it seemed logical that was the problem. Also, at some point the end cap had broken. As it has the main grounding point inside it and as I was taking the control panel apart anyway it made sense to replace it. Read more

Genuine Frigidaire part

Insert

5.0 (2)

By: Frigidaire

Part Number: 134768500

Genuine Frigidaire part

Insert

4.8 (5)

By: Frigidaire

Part Number: 5303212877

Vertical spring adjuster insert.

Do-It-Yourself Stories from Customers like You My washer started banging bad on the spin cycle and i would have to force the top open rearange the load and then it would work to finish after further review it was the springs David H. • Englewood , FL • April 06, 2018

Watched a few of your videos and ordered the springs and a insert, and actually got the parts right. I am not a Appliance repair guy but I am retired and I am pretty handy so I thought what the heck. I watched the videos, a lot of common sense, common tools, and plenty of time. My knuckles are busted up and a little blood, but I got it done. Was actually kind of rewarding. Works like a champ. The Videos, ARE AWESOME. Read more

Appliance

Appliance

Lawn & Garden

Need help finding dishwasher parts?

Need help finding dishwasher parts?

Need help finding dishwasher parts?

417-9781-2704 Parts

Tub Seal

Idler Pulley

Agitator Hub

Agitator

Trunnion (Washer Inner Tub Hub)

Cap

Bleach Dispenser

Transmission Assy

Power Resistor

Water Inlet Valve (Replacement), 1-Pack

Guide Clip

Transmission Pulley

Switch-Temp

End Cap

Insert

Insert