Dss25kstb Ge Parts

The old Ice stripper had broken fingers. I realized that even with the new one I had to shave some of the plastic to allow the rotating arms to clear as they push out the ice. I did this very easily with a box cutter razor blade. the Compartment tray was merely a remove and snap into place. Read more

Installed new stainless steel pan replacing broken original plastic pan and installed new rubber grommets for the compressor Read more

Our refrigerator takes care of my wife and I, along with our children when they visit, and the grand kids. Over the years, it's seen its fair share of wear and tear. Thankfully, nothing major has happened that hasn't been able to be repaired right here in the home, and by me. Our refrigerator is a GE side-by-side with an ice maker/water dispenser, and has held up well. I've ordered parts for it from AppliancePartsPros.com for all of its repairs, and while GE/Frigidaire have been changing out a... Read more

The auger gearbox shaft had a spot that was stripped of threads which prevented the auger drive from spinning the ice down the chute. I replaced the auger motor/gearbox assembly, the auger drive as it had to be cut off the shaft, and the 3 mount bolts that hold it all in place. Whole job took 30 minutes from start to finish which included cutting off the drive bracket. Read more

Replaced the housing the water filter screws into. Water works fine now. Read more

I replaced the Evaporator Fan Motor the brackets were rusty so I ordered them. Read more

Great site to DIY! Purchased fresh produce drawer railing and parts. Fixed in under 10 minutes. Thanks so much! Read more

Replaced the hinges and all parts pertaining to hinges on the refrigerator door. Total cost was approx. $83 and it took 1 hour this morning (Saturday). Now the door is closing tightly. The refrigerator is 10 years old. GE brand. Read more

Replaced them. Read more

The problem was most likely the evaporator fan motor but it could have been a bad blade, loose parts or bad motor mounts. Hard to tell without taking everything apart and inspecting. Since fridge was 17 years old I decided to order the entire evaporator fan assembly as shown in the parts diagram including fan blade, motor brackets, motor, motor mounts, screws, etc. Getting to the assembly involved removing the ice maker unit plus the entire rear inside of the freezer section. Parts cost around... Read more

My husband ordered and replaced the water tank inside the refrigerator in the back. Read more

Replaced the hinges and all parts pertaining to hinges on the refrigerator door. Total cost was approx. $83 and it took 1 hour this morning (Saturday). Now the door is closing tightly. The refrigerator is 10 years old. GE brand. Read more

I removed all of the interior components in the refrigerator compartment for a good cleaning and to make sure no other issues. Originally, all of the parts manuals showed that I had to purchase the entire plastic housing, foam insert and fan (WR17X12490). Searching the web, I found a few others who had the same problem and had actually found that you could order just the evaporator fan (WR60X10184). I also ordered several of the plastic shelf support pegs that had broken over time. The... Read more

I ordered a replacement auger from AppliancePartsPros.com. Upon receipt of the new auger, I watched the repair video and took the ice crusher apart. I found several other parts that needed to be replaced as well. Once All the parts were received, I again watched the video. The video was not specific enough to show how to reassemble the ice crusher blades and the two types of washers. I found another video on YouTube that walked me through specific details of assembly and everything went... Read more