Gsh22jdbbb Parts

Ordered the new shelf from Appliance Parts Pros, which was a genuine OEM part and much less expensive than the GE Store. Lifted the old shelf out, popped the new one in and it was done. two minutes. Read more

First I ordered a new ice door seal, spring, and crank, figuring the condensation in freezer and door was caused by ice door not sealing. Turns out the solenoid for the ice door was completely rusted and was the primary cause, if it had been replaced early, it would have saved the dispenser board. What then happened was the moisture in the freezer door damaged the control board rendering dispenser controls inoperative as well as the heater around the dispenser. Now the freezer door is dripping... Read more

I ordered the upper and lower cam riser, replaced them, and adjusted the door and the door works great. I've bought many parts in the last 10 years from AppliancePartsPros for this 20-year-old side-by-side refrig. Still works great. Thanks, ED Read more

The front wheel assembly replacement (WRXO2X12454) was straightforward and easy to do. Took maybe 30 minutes start to finish. The rear wheel assembly (wheel WRO2X10695 and axle WRO1X10604) that was more involved as the original wheel axle is actually a rivet that you have to cut out. 1. I used a vibrating multitool with a carbide blade to cut the axle out. Had to use a pair of vise grips to hold the rivet to keep it from spinning while cutting it. 2. The new axle I drilled a 2mm hole thru the... Read more

Replaced Ice maker very easy. Read more

Swapped it out for new tube. Take 5 minutes and zero effort. The drain tube will clog with mold. You can clean it out but the tube will clog again despite's you best efforts as the tube wall provide a great habitat. Ordered new tubes to facilitate swap-outs. Old tubes can be cleaned but will recolonize quickly. Read more

Replaced shelves Read more

Ordered replacement parts. Had trouble attaching handle with gasket. Had to look at vege draw to figure it out. Read more

I had 2 parts that were cracked, so after changing the cracked parts as well as the dispenser switch, it was back to working normally. Simple to make the needed repairs and the videos provided on your website really helped in being prepared. Read more

I removed the drawers and old rails, and screwed in the new ones. It was very straightforward. Read more

Once I got the part in the mail, I washed it and installed it in less than 2 minutes. Didn't need any tools! Read more

I had to replace the Combined Hmi Asm Bk. I watched a video online about how to remove the part and it took around 15 minutes to replace. The new part works great and extremely fast delivery by appliancepartspros.com! Read more

I had to disassemble the ice bucket, there were three screws to remove the cover, one screw and a tension spring that holds the bar in place that controls ice cubes from crushed ice. The hardest part was removing the plastic chamber where the ice crushing blades are attached to the auger, I had to use a couple of butter knives to spread the outer ice bucket away from the inner ice chamber because they had those funky plastic lock-in tabs that lock the ice chamber in place to the ice bucket. I... Read more

Pulled broke one out replaced with new one. Read more

Replacing the roller assembly corrected the problem. The key to replacing the roller assembly is elevating the refrigerator high enough to remove the roller assembly. (1) Raise and secure the refrigerator, (2) remove the metal bar across the bottom of the refrigerator to provide adequate access to the roller assembly (2-screws), (3) remove the roller assembly adjustment screw, (4) pry the roller pivot pin out, (5) pull the roller assembly toward the front of the refrigerator to remove, (6)... Read more