Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Freezer icing up or fridge won't cool? This electronic control board manages compressor, fans, and defrost cycles. DIYers report 5-10 minute installs.
After some simple troubleshooting, determined that it was likely the (rear) main control board. Once the new board arrived, it was installed in 5-10 minutes once the refrigerator was pulled out from the wall and the area cleaned up a bit. My only negative feedback was that delivery was too slow by today's standards. Fedex Post was used and in my experience it usually adds an extra 2-days compared to other ground shipping methods. The part was ordered on Sunday night. It shipped out of... Read more
Replaces broken or cracked door closure lever assembly in your refrigerator. Installs at base channel under kickplate to help doors close properly.
Replaced upper and lower thimble's, lever arm, cam closure. Door stop was not the problem, but ordered it and replaced it too. The door of course has to come off, remove the top hinge, and lift it away. Lubricated moving parts with silicone spray. Be sure and put the door back in the open position, so the lever arm and cam closure can properly interact, then close the door. Remove the plastic grate at the bottom to get at the lever arm. Presto. Problem gone. Don't put excessive weight... Read more
Seals freezer door to prevent frost buildup and air leaks. Replace if torn, warped, or causing moisture issues. Verify fit with your model number.
Ordered replacement seals for both freezer and refrigerator sides. Followed directions that I had found on YouTube. The installation in a nut shell is warm the seals in a bathtub with very hot water for at least 2-3hrs then place the seals. Then warm the seals with a hair dryer as needed. After getting the seals out of the hot bath the installation took all of 20-25 minutes for both seals. Read more
Replacement cold water reservoir tank for refrigerators. Installs behind the crisper drawer. Replace if cracked, leaking, or causing contamination issues.
I replaced the supply line to the fridge - no change in taste. I replaced the MWF manifold and tubes, the water inlet valve and the water storage line. That did it, good tasting water again! The ice still has a bad taste, so I'll replace the supply tube from the valve to the ice maker. Overall, replacing these parts was easy and the videos from Appliance Parts Pros helped. Read more
Seals your refrigerator's fresh food door to keep cool air in. Replace if door won't seal, fridge won't cool, or gasket is torn. Confirm fit by model.
We replaced both the fresh food door and freezer door gaskets. Old gaskets must have lost their magnetic abilities. Read more
Replacement rear wheel for refrigerators. Mounts to the bottom rear frame to enable smooth rolling for cleaning and repositioning. Order if cracked or missing.
The front wheel assembly replacement (WRXO2X12454) was straightforward and easy to do. Took maybe 30 minutes start to finish. The rear wheel assembly (wheel WRO2X10695 and axle WRO1X10604) that was more involved as the original wheel axle is actually a rivet that you have to cut out. 1. I used a vibrating multitool with a carbide blade to cut the axle out. Had to use a pair of vise grips to hold the rivet to keep it from spinning while cutting it. 2. The new axle I drilled a 2mm hole thru the... Read more
Replaces a worn or broken door closure cam on your refrigerator's fresh food door. Installs at the bottom of the door to engage the latch mechanism.
Refrigerator won't cool or compressor won't start? This compressor start relay and overload powers the compressor during cooling cycles. DIY repair.
We isolated a burning smell in our kitchen to our refrigerator, GE Profile PSS23MGTCCC which we purchased in November of 2006. This occurred at 3AM on 29 January 2015 and I am thankful that my wife got me up to investigate this odor. I unplugged the refrigerator. I plugged the refrigerator back in at 6AM thinking it had time to cool. The burning smell happened immediately and I unplugged the refrigerator again right away. My son in-law looked up some possible issues that could have... Read more
Ice won't dispense or auger spins freely? The drive coupler connects the motor to the auger. Moderately easy DIY repair with pliers and patience.
This was a two and half year issue as different things failed at different times. I would get one part, then another would fail. Ultimately, I got to a point where what failed, I hadn't been ordered the part yet. The seal on the freezer door took three bathing's before it plumped up and un-creased. The directions on the box it is shipped in said to heat the seal up in hot water then cool it down with tap water. I didn't need to do that. It took a lot of massaging of the seal, but... Read more
Replacement door closure spring for refrigerator hinges. Installs on door hinge assembly to provide tension for proper closing. Needed when broken or worn.
I replaced the lever asm. and spring Read more
White slide button for refrigerator crisper drawer assembly. Replaces broken, cracked, or missing drawer slide buttons. Measures 3.5" wide by 1" high.
Ordered new parts Read more
Replacement set screw for refrigerator door handles. Secures handle assembly to door. Needed when original screw is lost, stripped, or damaged.
I ordered the replacement handle parts based on the model number. Read more
Channels water from the fill tube into the icemaker mold. Replace if cracked, broken, or dislodged, causing water leakage or ice buildup in freezer.
Replaced the stripper and fill cup - turns out that the fill cup came with the locking tab broken off. The stripper had a missing paddle, and ice cubes would jam and shut down the ice maker periodically. Let the ice maker warm up after you remove it so the plastic is not so brittle. You have to pry the old stripper out. Make sure the new one locks all across the front. My refrigerator has the ice maker mount toe the side instead of from the hangers in back. I wasn't sure how to remove it,... Read more
Pan cover wheel for refrigerator fresh food drawers. Replace this roller if worn, cracked, or broken to restore smooth drawer sliding and support.
Used the schematic provided to select the parts needing replacement and placed the order. Parts arrived and swapping new for old was simple. For the most part it was a matter of taking out the old and putting in the new. There were a few screws with wheels to replace but that was easy as well. Before purchase I searched several different sites and found all the parts needed. I compared prices of each item as well as shipping cost. Prices for each item were nearly identical between sites... Read more
Replaces a broken or worn freezer door cam closure on side-by-side refrigerators. Installs on the door to control opening range and secure latching.
Watched an online repair video first. Then removed hex head screws on bottom of door. Replaced broken part. Read more
Damaged or cracked dispenser trim? This trim snaps around your refrigerator's water and ice dispenser opening for a finished look. DIY repair in 20 minutes.
After viewing your video the job went as planned and took maybe 20 minutes. Read more