Maytag Mdb4030awb Parts

• Will not dispense detergent

I found the videos on dishwasher repair that AppliancePartsPros offers and determined the likely cause of the problem. I removed the door cover and found soap caked on the back. I cleaned the cover and switched the wax motors to see if the clean rinse motor was good and ran a tested cycle. No improvement. I ordered two new wax motors for the Maytag dishwasher and those arrived in a few days from AppliancePartsPros. I replaced the old motors and ran a test cycle. The soap tray opened correctly.... Read more

• Leaking

Took off cover, installed new parts. Read more

I first installed the inlet pump with no results. I then ordered a Control Switch and Float and Nut. This fixed the problem. Everything comes out so clean. I also replaced the filter which allowed me to clean debris around old filter. It is also easier to replace all these parts with the dishwasher pulled out and tilted on its side. I had to pull mine out to unplug power to the dishwasher. Read more

I installed the door latch assembly and handle. It worked fine after that. Read more

Replaced left hand rack adjuster. Read more

The foam was shot on the detergent cup lid. Hard as a rock. Causing caking problems, dribble down the inside wall of the door and leaving lumps of detergent. Cut the door in half wit aviation snips and pulled out the two halves. Discovered at this point that the spring had gone soft. Bought one ahead of time, so I was set. Put the spring on the left pin, put the spring pin in the door, slipped the door into place (open) and put the right pin in with pliers. Door snaps open now. Read more

Mice and insulation gone. cleaned dishwasher replaced insulation pad. reinstalled dishwasher smell is gone all is well. Read more

The foam was shot on the detergent cup lid. Hard as a rock. Causing caking problems, dribble down the inside wall of the door and leaving lumps of detergent. Cut the door in half wit aviation snips and pulled out the two halves. Discovered at this point that the spring had gone soft. Bought one ahead of time, so I was set. Put the spring on the left pin, put the spring pin in the door, slipped the door into place (open) and put the right pin in with pliers. Door snaps open now. Read more

The initial problem was just a simple blockage on the filter screen...until I dropped a screw. So, I had to take the rest of the insides apart to retrieve it. The original impeller would not come off easily, so I tried to pry it off. Naturally, that caused the threaded portion to break. The new impeller went on much more easily than the old one came off, and the dishwasher is back in action. Simple repair; there's really not much to the inside of this thing. Read more

I ordered new replacement parts. Read more

Replacement parts fit perfectly and videos thoroughly explained install them Read more

After discovering your web site and reading of others issues I ordered a door seal (my old one was a little short on the right side) a detergent door grommet, and the 2 water deflectors ( I decided to cover all the bases while I was at it. Very simple job with the information provided on your web site. I certainly have the confidence to tackle other appliance repair now. Read more

• Not cleaning dishes properly
• Leaking
• Noisy

I first wanted to get the dishwasher running, before ordering the spring links. So I disassembled the pump / motor assembly to determine the reason the motor would not start. My wife cleaned all of the parts in the pump assembly. I took the motor apart and discovered that the lower bearing ( a sleeve type bearing) was dry and dirty, and was the culprit for the motor seizing. I cleaned up the bearing and lubricated it with SAE 20W. I also packed felt inside the cavity adjacent to the bearing.... Read more