Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Ice bin won't release or latch broke? This ice bin latch spring provides tension to secure the ice container properly. Easy 10-minute DIY fix.
Easy to remove the metal parts from the old bin. The only problem was that the screw that holds the adapter has red thread locker and screwdriver rounded off the head of the screw. Drilled the screw and heated the screw to loosen the thread locker and used an ease out to remove the screw. Read more
Replacement fastener screw for appliances. Secures panels, trim, clips, and components. Needed when original screws are stripped, missing, or damaged.
Removed the handle with two screws on the inside front and pulled out the custom wood panel. Pulled the compactor out from under cabinet. Tipped it over on back of unit, supporting it with a little foot stool. Unscrewed two lower screws at bottom of unit holding black trim panel (that held wood panel in place) and lower black rubber flap. Removed two screws on lower outside side of unit that held the foot pedal. Slid off black U shaped metal frame from top of compactor towards bottom. Slid on... Read more
Fix a water dispenser that stopped working or won't activate. This dispenser lever replaces broken actuator assemblies. Moderate DIY repair.
The water dispenser stopped working on my Sears Kenmore (Whirlpool) side-by-side refrigerator and after much research on the web I purchased the parts that commonly failed for this condition. I should have first taken the dispenser assembly apart but I didn't--it looked a little too intimidating to do twice. As it turns out, what actually broke was the plastic assembly that holds the water actuator switch in place so the dispenser lever could not strike it. I was able to secure it in place... Read more
Fixes freezer ice buildup and warm refrigerator sections by melting frost from the evaporator coil. Restores proper airflow and cooling performance.
Ended up being the defrost sensor. Ordered the heater and control board just in case. Started with the control board still didn't defrost. replaced the sensor and all is well. Super helpful tech staff answered all my questions... Read more
Plastic water supply tubing connects your water source to the ice maker or dispenser. Replace if cracked, leaking, or damaged. 1/4" diameter, 8 feet long.
Replaced the broken parts. The water leak was caused by the drain valve not directed into drain pan Read more
Replacement support stud that holds refrigerator shelves securely in place. Needed when original peg is broken, cracked, or missing from shelf wall.
Myself Read more
Secures the bottom grille to your refrigerator frame. Replace if the original clip is cracked, broken, or missing and the grille won't stay in place.
I had to remove a metal panel at the bottom back of the freezer as well as a couple of shelf slides in order to get at a drain pan in the back. It was frozen solid, so I stabbed at it with an ice pick until I broke through, followed up by poking a coat hanger in the drain hole to clear as much as I could, then poured a little boiling water over it to follow up. After screwing it all back together, the ice maker surprisingly was working again in less than 20 minutes. I also replaced a broken... Read more
Black plastic grille covers the lower front opening of your refrigerator. Replace if cracked, broken, or missing to restore appearance and protect components.
Snapped in the bottom of the fridge. Read more
Fix a water dispenser that won't stop flowing or won't dispense at all. This limit switch monitors dispenser operation. Simple 5-10 minute repair.
I replaced the switch which was bad and also replaced the water inlet valve. Read more
Soap or rinse aid dispenser not opening? This wax motor actuates the dispenser door release. DIYers report 15-30 minute repairs with basic tools.
I found the videos on dishwasher repair that AppliancePartsPros offers and determined the likely cause of the problem. I removed the door cover and found soap caked on the back. I cleaned the cover and switched the wax motors to see if the clean rinse motor was good and ran a tested cycle. No improvement. I ordered two new wax motors for the Maytag dishwasher and those arrived in a few days from AppliancePartsPros. I replaced the old motors and ran a test cycle. The soap tray opened correctly.... Read more
Fix ice dispenser grinding noises and jams with this lower ice crusher bin. Supports crusher blades and restores smooth crushed-ice dispensing.
Connects portable dishwasher to sink faucet for water supply and drainage. Replace if coupler is cracked, leaking, or won't stay attached to faucet.
Installed a new hose and coupler and now it works perfect again. Had to take the top off of the dishwasher, which was just a few screws and take the old hose out, install the new one and within an hour, my dishwasher was running again. This company shipped my parts in "lightning speed" and I am very satisfied. Read more
Speed clip slides over panel edges to create captive threads for mounting screws. Replace worn, missing, or broken clips to restore secure attachment.
Replaced the water tube that went from the plastic tubing to the ice cube tray. Found that even though it was the same exact length as the original, there was only an extremely small gap from the end of the tube to a splash board. This may have been the root cause of my problems. Read more
Fix water leaks in your refrigerator's ice maker or water line. This tube insert reinforces plastic tubing for leak-resistant compression fittings.
Ice dispenser not working? This refrigerator ice lever activates ice release when pressed. Common fix for broken or worn levers. DIY-friendly repair.
Black touch-up paint for appliance exteriors. Covers chips, scratches, and worn spots on refrigerators, ranges, and more. 0.6 oz bottle with brush.
Replaced It With New One Read more