Sears 66515982990 Parts

1. To fix the leaks from around the door, I replaced the upper and lower door seals. These were purchased in a separate transcation, so they are not the parts shown here. The upper door seal worked as intended, but the lower seal would not stay in place on the lower edge of the door during a wash. Therefore I cleaned the grease and detergent off the old seal, and installed using silicone sealer/adhesive. The plastic edge pieces for the lower seal were supplied with the kit, and they installed... Read more

I had no hope of separating the panel from the frame without damaging the frame since the two parts were rusted pretty badly and the screws holding the panel to the frame were completely beyond salvage. So I had to replace both the panel and the frame. I ended up removing the electrical/electronic connections, removing the panel/frame from the hinge and then replacing it with the new parts. Took about 90 minutes but the hardest part was removing other items from the rusting frame without... Read more

• Won't start

I ordered the Door Switch Kit, along with a few other items. However, the switch kit was all that was needed. Isimply followed the instructions that came with the kit. It was necessary to cut the wires which connected to the wire assembly in the door of the dishwasher. I then connected the pieces from the switch kit and then connected the end pieces to the door. I closed the door, and started up the dishwasher. It worked as well as before. Read more

Replaced door lower seal and door gasket. Read more

Cleared out trash from pump. Made E-Z by your exploded views and videos. Replaced worn parts. Read more

Ordered new inlet water valve and float switch kit. After repairs it now works fine. However the water inlet valve outlet end for fill hose (not water source) and wire connections (supposedly for this unit) were oriented 180 degrees opposite. I had to gently remove the blue plastic valve off the metal support bracket and turn it around and press back in place. Fortunately it appears it was designed for either orientation. Also the solenoid had to be unclipped and also rotated. Again it was... Read more

First I ordered new dishracks from KitchenAid/Whirlpool. However, they don't make the "flex row" tines anymore and there was, therefore, a big "hole" in the dishrack that arrived. I could fit a large pot in the space, but no dishes (they'd fall through). KitchenAid and Whirlpool don't even sell the parts anymore. But, to the rescue comes AppliancePartsPros.com. I was able to order the correct parts and put them in with no difficulty, once I viewed the very handy video. Thank you so much. ... Read more