Ptc Unit Parts

I replaced the water lever/electric pressure switch. Immediately the washer ran like a new machine. No problems pausing or stopping to add water and draining as before. This repair is very simple and takes less than 10 min. All you have to do is remove two phillips screws on the panel just below all the controls. Once removed the pressure switch is on the left side with a clear rubber tube attached with a spring clip. Simply squeeze the clip together with some pliers and slide it down then... Read more

I had the problem couple years ago I bypassed unbalance switch it worked fine for a couple years and had the same problem again so ruled out unbalanced switch. Door lock light on and checked made sure wax motor pushed out all the way too the second switch for spin check OK, so took a chance on displacement switch x2. My family loves to over load it and also replaced by passed unbalance switch and boom every thing went back to normal. Its also good to clean every thing when apart. Read more

Vane - Removed the top cover (2 square screws). Spin the dryer until the vane of interest is at the top. Remove 3 (square) screws, replace vane and reinstall. Moisture Sensor - Remove phillips screw holding sensor in place. Reattach 2 leads (can be tricky) and reinstall. Longest part of this task was accessing the back of the dryer given its location in a closet. Read more

I replaced the relay assembly, and the freezer works better than new Read more

Replaced the temperature switch. Read more

I replaced the Water Level Switch. I ordered it from AppliancePartsPros.com. Installed the switch in (5)minutes. I was able to load my washer to the right water level that I selected. Read more

After watching repair videos, I decided I could order the parts needed and do it myself for less than a service call, not to mention the additional cost for parts markup and installation that a service technician would charge. I am very pleased that I did. I ordered the start relay, overload and capacitor with some help from Ilya at customer service to make sure I was getting the correct replacements. Installation was easy. The hardest thing was contorting my body into a position where I could... Read more

A quick search told me what the likely cause was. With the help of you site I was able to locate the relay and overload.In 2 days parts arrived.10 minutes to install. Now I have nice cold beverages in my garage again! Read more

• Will not stop filling with water

Put in water level switch Read more

Ordered a new power cord off this website Read more