Lbef3043kfn Control Board Parts
Genuine Ge part
By: Ge
Part Number: WE4X775
Replace a failed dryer timer to restore reliable cycle selection and timing. This dryer control advances the machine through selected cycles so loads run and finish on the chosen program. What it does
- Advances the dryer through cycle steps and governs timed run lengths.
- Used for selecting timed and automatic cycles; coordinates cycle changes.
- Common symptoms: timer won't advance, dryer stays on one cycle, or cycles don't complete.
- Replace when the timer knob fails to turn or cycles no longer respond to controls.
What's included Includes: 1 timer assembly. Install notes
- Disconnect power (unplug or shut off the breaker) before servicing to avoid electric shock.
- Access usually requires removing the control panel and unplugging the wiring harness; keep track of fasteners and connector locations.
- On gas dryers, shut off the gas supply before starting any work.
Do-It-Yourself Stories from Customers like You
Dryer had stopped heating Matt D. • Salisbury , MD • May 08, 2015
Replaced the heater unit because the heater coil had burned in two. The whole project took less that one hour. I also replaced the dryer timer since one of the cycles would not cool down as part of the process.
Read more
More
$145.41
- Compare At:
-
$171.58
- You Save:
-
$26.17
Genuine Ge part
By: Ge
Part Number: WE4X872
This dryer timer controls the length of the drying cycle and directs power to key circuits. Replacing a worn timer restores reliable cycle advance and proper shutoff so the dryer doesn't run too long or stall.
- Advances the dryer through the selected timed cycle and turns it off at the end of the set time
- Routes power to the drive motor and heating circuit through internal switch contacts
- Coordinates cycle selection via the control knob attached to the timer shaft
- Failure symptoms include: cycle not advancing, running continuously, won't start on certain settings, or intermittent/no heat
What's included: 1 timer assembly Install notes:
- Disconnect power before servicing; if gas, also shut off the gas supply
- Access the control panel and remove the rear cover to reach the timer
- Photograph/label wires and transfer them one by one to matching terminals on the new timer
- Mount the timer securely, align the shaft, reinstall the knob/dial, and test all cycle positions
More
$150.59
- Compare At:
-
$180.12
- You Save:
-
$29.53
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2161460
This temperature control thermostat regulates the fresh food compartment, cycling cooling on and off to maintain your setting. Replace it if the refrigerator section won't stay cold, overcools, runs constantly, or the dial no longer responds. What it does
- Monitors refrigerator (fresh food) compartment temperature via the sensing bulb/capillary
- Opens and closes electrical contacts to control the cooling system as needed
- Helps maintain consistent temperature at the selected setting
- Common symptoms of failure: warm fridge, food freezing in fresh food section, runs nonstop or short-cycles, unresponsive or no "click" at the dial
What's included
Install notes
- Disconnect power before servicing; work with dry hands
- Note/photograph wire positions and transfer to matching terminals; reuse original mounting hardware
- Route the sensing capillary exactly as original; avoid sharp bends or kinks and secure the bulb in its clip
- After installation, set to mid setting and allow up to 24 hours for temperatures to stabilize
More
$151.53
- Compare At:
-
$180.32
- You Save:
-
$28.79
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3387974
$5.95
- Compare At:
-
$7.08
- You Save:
-
$1.13