Hardware Hand Snowblower Show Bolt Nut Parts

I replaced the washer plate and new screw/washer part. Easy fix and back up and running in ubder 10 minutes. Read more

I ordered a replacement handle and screws. The process was very easy with the help of one of your "pros" who found all the parts needed and took my order. I didn't realize I was getting both a refrigerator door handle and a freezer door handle in one set, but now we have the freezer handle if we need it. Removing the old handle and installing the replacement was very easy. It looks great, in fact the replacement is metal, whereas the original was plastic, so it looks better than it ever did! Read more

Removing the bottom panel and watching the internals while the washer was running revealed a small drip from what appeared to be a plastic cam that was attached to a solenoid. The water was dripping from the shaft the cam attached to down into the solenoid. Being a DIY guy I pulled the washer out, turned it upside down and inspected the effected mechanism. It appeared that there was a seal on the shaft that was leaking. The water leaking into the solenoid caused it to rust and stick. A quick... Read more

The bar retainers just snapped in and the door handle can be replaced with three screws. Took about 5 minutes total. Read more

I pulled off the retaining clip with pliers then removed the old knob and timer dial. I replaced all the parts with the new ones and used pliers to reinstall the clip. The teeth on the new knob engage to select the cycle. https://www.youtube.com/watch?v=cQwLtRcHx9k Read more

• Door won't open or close

My 10 year old frig door was hanging down to the point it wasnt fully closing and sealing unless you picked up on it. I ordered a lower hinge bracket, upper and lower bearing, and spacer. My bracket was bent down a little due to my kids hanging on the door when looking at the bottom shelf and i discovered my bracket was held on by only two bolts when there was supposed to be three. I ordered a bolt too. I was able to remove the bottom hinge, remove door to replace upper and lower bearing and... Read more

Heating element nut had cracked causing a leak. Rather than run right out and buy a new one, I found the cracked nut and replaced it for about 11.00. Thank you Appliance pros. Quick shipping. Read more

I ordered a replacement handle and screws. The process was very easy with the help of one of your "pros" who found all the parts needed and took my order. I didn't realize I was getting both a refrigerator door handle and a freezer door handle in one set, but now we have the freezer handle if we need it. Removing the old handle and installing the replacement was very easy. It looks great, in fact the replacement is metal, whereas the original was plastic, so it looks better than it ever did! Read more

Took off the freezer door, took off the top hinge on the refrigerator door, replaced the handle, re-installed the top hinge and the freezer door. This is a two person job - one to remove the top hinge and replace the handle, while a second person holds the refrigerator door in place. Replacing the handle was easy. The most irritating part was figuring out what parts to order. The drawing of the refrigerator door (Drawing # 4) used to figure out what parts to order was not clear. I paid $8... Read more

Repair estimate was $250 parts, $250 labor to change out the circulating pump. I decided to do it myself. Pump was $166 from AppliancePartsPros. It arrived in 4 days. I looked at the video on their website, followed the instructions step by step and did it myself. They estimated 45 minutes. It took 2 hours.There are always minor differences so always take photos of yours. Suggest that you bag up all screws and pieces from each part as you take them off and label the bag. I had 12 bags with 2 to... Read more

No problem, 1 min to fix Read more

Ordered new freezer arm Read more

Ordered replacement parts from AP diagram Read more

I looked for a site that sold replacement parts for my make of GE refrigerator. I found AppliancePartsPros, and was very surprised at how organized it was. By entering the model number of my refrigerator, I was shown a set of (approximately) 8 general parts diagrams for my refrigerator. I chose the ice making/dispensing diagram. I matched the part that shattered (from use) to what was on the diagram. What I didn't know was how to install the part. I saw references by other customer comments to... Read more

I was getting really frustrated with our oven. It would preheat to the correct temperature, then slowly lose heat until it was down to about 200 degrees. So it took about two hours to heat a pizza! Finally decided to repair the oven myself, rather than pay $300.00 to have a repair person come out. Ordered the replacement igniter from AppliancePartsPros.com, and it arrived in two days. I followed the instructional video on the AppliancePartsPros.com website, and it was going well until I... Read more

No problem, 1 min to fix Read more