Parts for Kenmore 887.3279A (8873279A, 887 3279A): Tub And Basket Parts

Ice not dispensing or noisy dispenser? This auger cap secures the ice-transfer auger, restoring smooth operation and reducing grinding sounds.

Agitator not working or spinning loosely? This washer agitator bolt secures the agitator assembly. Simple DIY fix in under 20 minutes with basic tools.

Fix a washer that won't agitate or clean clothes properly with this agitator auger. Common repair for spinning issues. Moderate DIY installation.

Fix a washer agitator that won't turn or spins weakly with this lower agitator base. Restores proper wash action when worn, cracked, or stripped.

Washer tub ring that snaps onto the top of the outer tub. It acts as the tub cover and splash guard, guiding water back into the tub and supporting inlet or dispenser fittings to help keep the rim area contained.

• Attaches to the top of the outer tub as the upper splash guard/tub cover
• Directs water back into the tub; supports inlet/dispenser nozzles, if equipped
• Maintains proper clearance around the spin basket
• Common replacement signs: cracks, broken locking tabs, splashing from the rim, or rubbing at the top opening

What's included: 1 tub ring Install notes:

• Disconnect power and water supplies before servicing
• Lift or remove the top panel to access the tub rim
• Release locking tabs and detach any hoses/nozzles from the old ring; transfer fittings if needed
• Seat the new ring evenly; ensure all tabs fully engage. Reassemble and run a test cycle to check for leaks/splashing

Noisy spin cycle or loose tub? This spanner nut secures the washer tub to the drive shaft. Requires spanner wrench for installation. DIY-friendly.

Seals between inner and outer washer tubs to prevent leaks and moisture buildup. Replace if you notice water pooling or dampness. Verify fit with your model.

Leaking washer or clothes not agitating properly? This inner wash tub basket replaces your damaged drum to restore water containment and effective cleaning.

Washer won't spin or agitate? A worn drive block often causes spinning failure. This connects the transmission to the tub. Moderately difficult repair.

Secures hose connections to prevent leaks in your washer. Replace if you notice dripping at hose fittings or loose connections. Verify fit with your model.

Flexible water hose that transports water between laundry center components. Replace when original hose is cracked, split, leaking, or worn out.

Directs water from your washer to the drain outlet. Replace this tube if cracked, clogged, or leaking to prevent water pooling and potential damage.

Secures panels and components in place. Replace this fastener if stripped, corroded, or missing to restore proper alignment and eliminate rattling.

Seals the center post/agitator shaft to prevent water leaks during wash cycles. Replace if you notice pooling water under your washer. Confirm fit with your model.

Agitator barely moving clothes? Worn agitator dogs prevent the ratcheting action needed for proper washing. Simple DIY fix in under 30 minutes.

Fix a washer that won't agitate or makes grinding noises during wash. This cam kit with dogs restores proper agitation. DIY repair takes 10-20 minutes.

Missing or cracked cap letting water into the agitator? This protective cover seals openings and fasteners, preventing leaks and debris buildup. Easy DIY fix.

Distributes load under fasteners in your washer's agitator assembly. Replace if worn, broken, or missing to prevent looseness and noise. Confirm fit by model.

Seals the agitator cap to prevent water leaks into the agitator assembly. Replace if you notice leaking during wash cycles. Verify fit with your model.