Parts for Whirlpool WRR56X18FW00: 05 - Unit Parts

Fix a freezer that's not cooling or has frost buildup with this evaporator coil. Absorbs heat to maintain consistent temperatures inside the unit.

Includes fan blade.

Loud noise or freezer warming up? This evaporator fan blade circulates cold air over coils. Simple DIY fix—most repairs done in under an hour.

Freezer icing up or frost building on coils? The defrost heater melts ice from evaporator coils. Moderately difficult repair, about 1 hour install time.

Replaces a cracked, warped, or missing oven heat shield that protects nearby components from high temperatures. Direct-fit part restores proper insulation.

Catches water and condensation beneath your freezer. Replace this drip tray if it's cracked, warped, or missing to prevent floor damage from leaks.

Creates an airtight seal for your refrigerator fresh-food door to maintain proper cooling and reduce frost buildup. Replace if torn or loose. Check fit.

Evaporator coils freezing up or freezer not defrosting? A faulty thermistor may be the cause. This temperature sensor regulates defrost cycles. DIY repair.

Wire harness assembly for refrigerators. Connects electrical components throughout the unit. Replace if wires are frayed, damaged, or connectors broken.

Secures panels, trim, and wire harnesses in your refrigerator to reduce vibration and rattling. Replace when clips break or parts become loose. Confirm fit with your model number before ordering.

Rubber grommet that cushions wiring or hoses at sheet metal openings in refrigerators and freezers. Replace if worn, cracked, or missing.

Compressor won't start or kicks on and off? This run capacitor powers the compressor motor. A 15-minute DIY repair that restores cooling cycles.

Refrigerator not cooling properly? A clogged filter drier prevents proper refrigerant flow. Requires professional installation due to sealed system.

Terminal cover for chest and upright freezers. Protects electrical connections. Replace if cracked, broken, or missing to maintain safe operation.

Fixes freezer not powering on, intermittent operation, or unresponsive controls. This wiring harness restores electrical connections between components.

Freezer shelf retainer clip secures shelves in place. Replace if yours is cracked, broken, or missing to restore proper shelf support and stability.

Rubber grommet kit that mounts and cushions the compressor. Replace worn, cracked, or damaged grommets to restore proper support and isolation.

Replace stripped, missing, or corroded mounting screws in your refrigerator or freezer. Secures panels, brackets, and components for proper fit.

Rubber grommet for refrigerators and freezers. Protects wires and components from sharp edges. Replace if cracked, worn, or missing for proper fit.

This replacement tube routes water safely away from the appliance to prevent pooling and ensure proper draining. It restores intended water flow paths so the appliance can drain reliably and avoid leaks. What it does:

• Channels water from the tub/dispenser area toward the drain or overflow path
• Helps prevent water from pooling or leaking inside the cabinet
• Addresses symptoms such as standing water after a cycle, visible leaks, or water under the appliance
• Used where a damaged, cracked, or disconnected tube is causing improper drainage

• One replacement tube

• Inspect routing and hose clamps; replace clamps if corroded or brittle
• Securely attach both ends and confirm a snug, leak-free fit before use
• Disconnect power and water supply before attempting repair;

Replace your freezer's compressor drip pan if you notice water pooling under the unit. This pan catches condensation and prevents floor damage.

If your freezer runs loud or cooling is uneven, a cracked fan scroll may be disrupting airflow. This blower housing channels air efficiently for quiet operation.

Refrigerator making rattling or vibrating noise? This condenser bracket assembly secures the condenser coil to eliminate movement and noise.

Fix a refrigerator that's not cooling properly or running constantly with a new condenser fan motor. This part helps dissipate heat from the system.

Replacement mounting screw for securing panels, brackets, and components in appliances. Needed when original screws are stripped, missing, or damaged.

Fix clicking noise, poor cooling, or overheating compressor by replacing a cracked or warped condenser fan blade. Restores airflow across the coil.

Freezer not cooling or running constantly? A faulty condenser may be the cause. This replacement condenser helps restore proper cooling efficiency.

Fixes frost buildup or uneven cooling in your freezer. This evaporator cover protects the cooling coils and maintains proper airflow. Moderate DIY repair.