Parts for Frigidaire LCE462LW2: 05 - Washer-Tubs, Hoses Parts

Secures the washer's inner basket to the drive hub, keeping the tub centered and stable during spin. Replace if cracked, corroded, or bolts are damaged.

Trunnion support for washer drum assembly. Replaces cracked, worn, or broken trunnion that causes misalignment. Restores stability to rotating drum.

Horizontal suspension spring for washer drum support systems. Replaces worn, stretched, or broken springs that cause excessive drum movement or noise.

Suspension spring for washer drum support system. Replaces worn, stretched, or broken springs that cause drum instability or excessive movement.

Pressure tube connects washer tub to water level switch. Replace if cracked, kinked, or clogged to restore proper water level sensing in your laundry center.

This part has been discontinued by the manufacturer and is no longer available.

Washer won't fill with water or only fills with hot? The water inlet valve controls water flow into the tub. DIY repair takes about 30 minutes.

Fix loud whirling noise during spin cycle with this washer spin bearing washer. Supports the belt pulley bearing for smooth rotation. Video available.

A replacement bracket that secures the lid lock assembly to the washer cabinet, restoring proper lid alignment and latch engagement for safe operation. Fits the factory lid-lock hardware to keep the top lid stable during cycles. What it does:

• Holds the lid lock assembly in the correct position so the lid latch can engage reliably
• Prevents the lid from shifting or rattling during spin and agitation
• Helps restore normal start/lock symptoms when a loose or broken bracket prevents the washer from starting
• Works with the existing lid lock and strike to maintain safe operation

• Disconnect power to the washer before beginning any work
• Basic hand tools typically required; follow the washer model's disassembly steps to access the lock area
• Inspect the lid lock and strike for wear and replace if they show damage or prevent proper engagement
• After installation, verify lid closes and the lock engages before running a full cycle

Replacement fastening screw that secures panels, trim, or internal components in your washer. Needed when original is stripped, missing, or damaged.

Sems screw for dryers. Secures internal components and panels. Replace if screw is stripped, missing, or no longer holding parts firmly in place.

Fix leaking or noisy washer drums caused by broken trunnion bolts. This fastener secures the trunnion assembly to prevent water leaks and vibration.

Secure hose clamp for dishwashers. Replace if hoses are loose, leaking, or clamp shows wear or corrosion. Verify fit with your model number before ordering.

Replaces missing, stripped, or rusted 8-18 thread screws that secure dryer panels, brackets, and components for tight, rattle-free assembly.

Connects your washing machine to the household water supply. Replace this flexible inlet hose if cracked, leaking, or worn to restore proper flow.

Rubber washer that seals the connection between your washing machine's inlet hose and faucet. Replace if cracked, worn, or causing leaks at connection.

Red adhesive strip for washers. Secures components and panels inside the cabinet. Replace if peeling, missing, or no longer holding parts in place.

Clear adhesive for washers. Secures components and panels during assembly or repair. Replace if original adhesive has degraded, lost bond strength, or worn.