Parts for Whirlpool WRS331SDHM03: Dispenser Parts

Restore reliable, responsive controls with this user interface assembly. It reads your touch/button inputs and communicates them to the main control so you can select settings, start/stop cycles, and see status feedback as intended. What it does:

• Registers touch/button inputs and sends commands to the main control
• Provides status indication through UI LEDs/indicators
• Helps address unresponsive or intermittent controls and dark/no-display conditions
• Replaces cracked, moisture-damaged, or non-responsive UI modules

• One user interface assembly

• Disconnect power at the breaker or unplug the appliance before servicing
• Handle the board as ESD-sensitive; avoid touching connector pins and circuitry
• Transfer any reusable brackets/trim from the original part as needed; seat all ribbon cables and connectors fully
• Route harnesses carefully and verify connector orientation before restoring power

This genuine replacement fitting connects appliance water or fluid lines to internal plumbing, restoring a secure seal and proper flow. Use it to replace a worn or damaged connector and stop leaks or loose hose connections. What it does:

• Provides a sealed connection between a hose and the appliance plumbing
• Helps stop leaks from cracked, corroded, or loose fittings
• Restores reliable water or fluid flow through the supply line
• Fits where the original factory connector was used

• One replacement fitting as shown

• Turn off water and disconnect power to the appliance before starting
• Inspect and replace any worn O-rings or gaskets as needed
• Hand-start threads, then tighten to factory torque; avoid over-tightening

This wire harness connects multiple electrical components so your appliance gets reliable power and signal routing. Replacing a damaged harness restores proper electrical connections and can stop intermittent operation or complete failures. What it does:

• Routes power and control signals between the appliance control and components
• Restores missing or intermittent electrical connections that cause faults or loss of function
• Prevents shorts from damaged or frayed wiring when replaced
• Matches OEM connector locations and lengths for a direct fit

• One complete wire harness assembly as shown

• Unplug the appliance or disconnect power at the breaker before starting
• Take photos of existing routing and connector positions to ensure correct reassembly
• Disconnect and reconnect connectors carefully; avoid pulling on wires
• Route harness away from sharp edges, moving parts, and high-heat areas; secure with original clips or ties

This retainer is a small mounting clip that secures an appliance component or assembly in place to prevent shifting and reduce noise or wear. It restores proper fit and alignment where a worn or broken clip allows movement. What it does:

• Holds panels, trim, or small assemblies securely to their mounting points
• Prevents rattling, shifting, or misalignment caused by a missing or damaged clip
• Helps maintain proper spacing so seals and connections stay aligned
• Works as a direct-fit replacement when the original retainer is broken or missing

• One retainer

• Disconnect power and, if applicable, water supply before starting any repair
• Remove surrounding fasteners or trim gently to access the clip; avoid forcing plastic tabs to prevent breakage
• Replace with the exact part number and ensure the component is seated fully before reassembling