Todd M Hernando , MS August 24, 2014 Appliance: Whirlpool 24" Built-In Electric Double Oven Std-Clean Lower Self-Clean Upper RBD305PRS00 Electronic control board I had been experiencing my oven shut off and not come back on without me flipping the breaker to reset it. After doing so several times over a period of a couple of weeks it finally bit the dust and didn't come back on after flipping the breaker. I spoke with a helpful and friendly tech at AppliancePartsPros.com who agreed with my opinion that the Electronic Control Board in my oven had gone bad. I then ordered the correct part from AppliancePartsPros.com which had one of the best prices I could find on the web. The part arrived within two days and I was able to install and have my oven back up and working again. The most difficult part is pulling the fairly heavy double oven out from the wall a few inches so that all screws holding the panels can be reached. After getting to the screws and figuring out how it comes apart it only takes unplugging the old board and plugging the new one in. I now have a happy wife and have been very pleased with the service and prices at AppliancePartsPros.com. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers
Eileen H Dallas , TX December 08, 2016 F2 error code Ordered control panel and replaced the panel Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Gustavo J Las Vegas , NV November 07, 2016 No display on control board Replaced Control Board Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Frank H Artesia , NM October 16, 2016 Electronic control board went out Ordered new control board Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Eric D Linthicum , MD September 12, 2016 Appliance: Whirlpool 30" Built-In Electric Double Oven Convection-Upper Self-Clean (Gold Line) GBD307PRQ01 Control panel blanked out while wife was wiping it I watched your youtube video on this EXACT model. You guys made it look so simple so I ordered a new one an the install went without a hitch. Thanks very much. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers
Edwin A Orlando , FL August 22, 2016 Appliance: Model ON THE APPLIANCE The electronic control board The repair take 1-1/2 hours, thank you Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Screwdrivers
Patricia D Mint Hill , NC May 09, 2016 Double oven didnt work!! I order the control board ...cost me only $292 it was on sale...we installed and now I have my double oven working!!!! So so happy!!!????????the delivery was next day Amazing!! They told if the piece didnt work I will be able to return it , with no problem!!! Thanks a lot!!! Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
John L Prairieville , LA May 02, 2016 Circuit board went out Replaced board Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Pliers, Screwdrivers
Thomas D Roanoke , VA April 17, 2016 The electronic control board was not operating After reviewing the the troubleshooting guide posted on line and at Appliance Parts Pro I was able to determine that the control board was bad. The on-line (You Tube) video for replacing the board for an in wall double oven was very helpful and only took about 45-60 minutes to replace and button everything up. Additional note, I reviewed several on line parts store and Appliance Parts Pro was the most competitive. I have bought and replaced several different appliance parts through the years and always found your prices at the lowest available. Thank you. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers
Ped B Azusa , CA February 13, 2016 Appliance: Whirlpool Built In Oven - Electric GBD307NKQ0 Panel light was dim and panel buttons were not working on double wall oven Ordered parts Monday night. Got parts Wednesday afternoon. I replaced the control board and the glass panel. If you label the wires, putting them back in the right place is easy. The door latch wasn't working right. I manually "closed" the latch with my fingers, then turned on the auto clean. The latch tightened. I turned off the autoclean and the latch returned to the proper place and the latch worked proper again. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers