General Electric Switch

• Won't start

Replaced lid switch and capacitor Read more

Worst part of job was sliding stove out from wall. Remove 4 small screws from shield on top of stove, disconnect two connectors from switch rocker, push lock tabs inward so you can push switch rocker outward from back toward burners threw frame of stove, insert new unit until click locks, reconnect wires, and reinsert shield back on top stove and secure with 4 screws removed earlier. Easy job, part shipped from AppliancePartsPros.com Fedex ASAP. Read more

Disconnected ( already tripped) breaker in the panel. Lifted cooked top unscrewed the glass top and set aside. I took the picture of the wires connected to the control on my ipad and replaced broken control. reconnected the wires as per picture. Cleaned the greased glass top and replaced the infinite switch seal for the broken control. Then reinstall glass top back on the cooktop and put the cooktop back in in place. Enable breaker in the panel and now i have good working cooktop again. ( do... Read more

By replacing the switches. Read more

My cooktop repair was a total success from start to finish. I reviewed and later followed the APP repair video, which helped me decide if I wanted to tackle the repairs and guided me right before I started. The APP phone staff member was very helpful verifying the parts I had identified online using the model number of my older GE Profile cooktop to locate and view the correct online exploded view diagram. I told him it was a pleasure working with him. The parts arrived within 3 days of... Read more

• Element will not heat

Talked to a representative at your company they said it was probably the infinite switch. I purchased all four switches, replaced all four burner switches. Very easy to do. In less than an hour to replace all four. Read more

Replaced faulty latch with new latch. New latch was different configuration, but the fit was okay. The only issue was that the wires to the electric motor were just barely long enough. Overall easy repair if you have a T15 Torx bit, phillips screwdriver, and 1/4" nut driver. Hardest part is removing the gas cooktop to gain access to the cleaning latch. 0. Turn off electric to stove; remove the cast iron grates, center caps/orifices, and catch pans from the stovetop. 1. Disconnect the... Read more

We replaced the Infinite Switch. Read more

• Won't start

Turned out the little switches on the knob shaft had corroded and were staying on. There was constant continuity showing with an ohm meter. Replacing the switches was very easy (always disconnect power to the unit before servicing). Bought a new ignitor module as a backup as they do go out of production after 10 years or so- another cheap and easy fix if needed in the future. Read more

The new controller work Read more

I unscrewed the 3 Phillips screws on the back of the dryer controls housing, then it folds forward for access to each control switch. the old one popped out, and I swapped the wires using a needle nose pliers, one by one, from the old switch to the new switch. The part was an exact fit, and popped right back into the housing. I screwed the 3 screws back in, pushed on the new knob, and it looks and works like new ! Read more

Found best price for replacement switch at @ AppliancePartsPro. But took another day to find procedure on how to replace. Ordered switch on Mon before 5:00pm and & paid for 2nd day delivery. Got email from FedX, delivery not scheduled until Fri 29th. Wife was upset; but I got lucky: it showed up Wed afternoon. Took 20 minutes to replace. Read more

I took the cook top of its support disconnected the electricity took the part off the panel and replaced the faulty control. Read more

• Element will not heat

Ordered the element control for my dual front right burner and a infinite heat switch for my left front large single burner. Removed cooktop and followed the instructions video given with the parts online. Process was simple and everything on my cooktop is working like it is brand new. The only problem I have is with the online chat, save time by calling in and talking to someone as the people I talked to online (4 of them) are in such a hurry to get to the next call they gave conflicting part... Read more