Kenmore Range 665.72174302 (66572174302, 665 72174302) Parts

I have a Jennair jjw9630cas double wall oven, and after a few years I noticed that the light would not go out, first in the bottom oven, and then in the top oven. After doing some research I discovered this was not uncommon, and the fix usually involved replacing the hinges and/or the hinge receptacles. It didn't look like a difficult fix so I ordered four new hinges and four new receptacles, which arrived quickly. I found a video on YouTube that showed how to replace the hinges and it... Read more

• Oven is too hot
• Little to no heat when baking
• Won't start
• Oven not heating evenly

When bake was set, the stove would function normally, it would show pre-heating then get up to temperature and beep twice like normal when it reached the set temperature. Shortly after it would start beeping and scroll “ fault detected, press start to try again” across the display. Pressing start did not resolve, the message would continue to post and the pizza inside was burnt. We noticed the broil element was glowing. This model stove does use the broil element for backing but it... Read more

• Won't start

There are hex screws keeping the igniter in place. I think they were 5/16...so you have to have a socket wrench. The space is kind of tight, and it's all on the right side, so if you're left handed (like I am) it's going to be a challenge to get the hex screws out without dropping them. Dropping them isn't too bad if they don't fall into the hole the gas pipe is coming through. Unfortunately one of them fell in there, and there's no getting it out of there. I had a machine screw that fit, so I... Read more

Took the stove apart*, saw where the mouse had made a nest. It was kind of like a hotel room after a rock star had used it. It was nasty, is what I'm saying. I removed the insulation, which immediately went into a garbage bag and was placed outside, whereupon I took off and nuked the site from orbit. It was the only way to be sure (actually it was disposed of in the proper manner, no nukes were detonated in the course of this repair). Anyway, I ordered the insulation from this site, which was... Read more

I have tried to remove the burner assemblies by removing the torx screws but they were badly rusted, and unfortunately they all were broken during removal. I just discarded the ruined orifices and assembled the new orifices and burner assembly. Read more

Replaced switch with back cover off and power plug pulled. The replacement switch was the same as old, was easy to pull off wires and push on new one. Also replaced torn door gasket with new one and was a exact replacement both only took less than a hour. Read more

Replaced It With New One Read more

Touch up paint Read more

I used the oven model number to find the replacement parts online and Appliance Parts Pros had the parts I needed at the lowest cost compared to other online retailers. This repair only required a screwdriver, but it took time to figure out where everything belonged since the oven instruction manual was not very informative for a do-it-yourself fix. Read more

• Element will not heat
• Won't start
• Gas igniter glows, but will not light

Replaced ignitor. Read more

I used the oven model number to find the replacement parts online and Appliance Parts Pros had the parts I needed at the lowest cost compared to other online retailers. This repair only required a screwdriver, but it took time to figure out where everything belonged since the oven instruction manual was not very informative for a do-it-yourself fix. Read more

I ordered a new socket and replaced the socket and now we have a light in the oven. The project took about 10 minutes and was easy done. Read more

I did a search online for inner door glass replacement pieces and came across a youtube video made by appliance parts pros. After watching the video, I was certain that this was a repair I could do myself. I ordered the glass and it arrived the next afternoon. That evening, I brought the video up on my computer, gathered a screwdriver, some gloves and a towel to lay the door on when I put it on the table. I watched the video as I did the repair, starting, stopping and backing up as needed. ... Read more

Using the parts I ordered, I replaced the glass myself following the very helpful video on your web site. Read more

Replaced old igniter. also purchased new screws for burner and igniter assembly since old screws were corroded from spilled food/fluids etc over the years. made the installation much easier. If you need to replace a worn igniter, do yourself a favor and go to hardware store and get matching replacement screws or buy new with igniter. Now my front right burner lights every time with just a click or two. Very pleased. Read more

Ordered a replacement panel. Item arrived exactly as described. Used the Youtube instructions. Took all of 5 minutes to replace. Thanks! Read more