Kenmore Washer 110.91587210 (11091587210, 110 91587210) Parts

Rear panel pad cushions and insulates the appliance's rear cabinet to reduce vibration, noise and rubbing against the back panel. Replacing a damaged pad helps stop rattles and protects internal components from wear. What it does:

• Provides rear-cabinet cushioning and thermal/abrasion protection for the back panel.
• Dampens vibration and reduces operational noise.
• Prevents direct metal-to-metal contact that can cause rubbing or wear.
• Common symptom fix: reduces rattling or vibrating noises from the appliance rear.

• Always disconnect power (and gas, if applicable) before starting any repair.
• Remove the rear access panel to access the pad; replace using the original mounting points, adhesive or clips.
• Inspect surrounding insulation and mounting hardware; replace any damaged fasteners.

This agitator cap is the top cover for the washer agitator/auger assembly, keeping the agitator hardware protected and holding the auger components in place. It restores a finished appearance and ensures the agitator operates without interference. What it does:

• Covers and protects the agitator bolt and internal auger components from debris and fabric
• Helps keep the agitator secure and centered during wash cycles
• Can reduce rubbing or noise caused by a cracked, loose, or missing cap
• Supports proper fit of the agitator assembly for smooth agitation

• One agitator cap assembly

• Disconnect power to the washer before starting any repair
• Remove the agitator per the OEM instructions to access and replace the cap
• Inspect surrounding components (bolt, washer) and replace any worn parts as needed
• Use proper tools and wear gloves to avoid cuts from sharp edges

Use with motor 357282.

This rotary cycle switch lets you select wash or dry cycles and settings using the front control knob, restoring user control of cycle selection and timing. It's a direct-replacement control interface component for affected consoles. What it does:

• Replaces the worn or damaged selector that lets the user choose cycle types and options
• Routes the chosen position to the console so the machine starts and advances through cycles
• Common symptoms: knob feels loose, cycle won't change, or the appliance fails to start or respond to cycle selection
• Matches the original mounting and electrical connections for a straightforward swap

• One rotary cycle switch (selector)

• Disconnect power (and gas supply for gas models) before starting any repair
• Remove the console/control panel trim to access and replace the switch; keep track of screws and connectors
• Note the original knob position and orientation when removing the old switch to ensure correct alignment on install
• After installation, restore power and run a test cycle to ensure proper operation

Motor mount to gear case.

For mating plug use 691707.

Color: White. Size: 1 qt. can. Acrylic appliance paint.

Kit includes 2 sleeves.

Installation instructions included.

Used for control panel.