Kenmore Freezer 253.44753110 (25344753110, 253 44753110) Parts

Loosened the top half screws, pulled the old seal out, put new seal in, snugged top screws, repeated process for the bottom. Went well, no problems. Read more

Had a friend who is an appliance repair tech. Replace the evaporator, the heater coil, and the filter/drier. Parts were soldered together and the compressor was put under vacuum. Then, charged with 5 oz. of refrigerant. The freezer works great now! Read more

I determined that it was a problem that occurred during the defrost cycle by resetting the GFCI outlet and forwarding the defrost timer until the defroster came on. Once the defrosting began, the GFCI outlet would reliably trip. I took apart the shielding inside of the freezer and tested the defrosting without the heating element or the thermostat connected. Since that looked good, I tested for proper functionality of the thermostat by removing it, placing it in a working freezer, and checking... Read more

Ordered control panel and run capacitor and compressor relay (or controller as they call it). Control panel was the problem but after 10 years of running never hurts to replace a capacitor and relay. Read more

Had a friend who is an appliance repair tech. Replace the evaporator, the heater coil, and the filter/drier. Parts were soldered together and the compressor was put under vacuum. Then, charged with 5 oz. of refrigerant. The freezer works great now! Read more

Ordered a replacement Drain Hose. $9.95 shipping seems high for a $5.55 part but it was delivered next day. This was better than promised!!! I pulled of the old hose and replaced it with the new. No tools required. Working like a charm. Read more

Replaced the gear. Now it's making ice again. Perfect. Read more

Volt Ohmmeter test indicated defrost thermostat and heater were OK. Defrost voltage measured ~25 VAC. I ordered all the most likely repair parts, but thought the control board had failed. I replaced the control board and the freezer has been working properly for several days. I haven't decided whether to keep or return the unused parts. I damaged the paint removing the electrical control. There must be a trick to protect the paint from the putty knife and screwdriver. Read more

I placed a order for a replacement cord. It was an exact fit. Whole process was about 10 minutes max. Read more

My 10 year old frig door was hanging down to the point it wasnt fully closing and sealing unless you picked up on it. I ordered a lower hinge bracket, upper and lower bearing, and spacer. My bracket was bent down a little due to my kids hanging on the door when looking at the bottom shelf and i discovered my bracket was held on by only two bolts when there was supposed to be three. I ordered a bolt too. I was able to remove the bottom hinge, remove door to replace upper and lower bearing and... Read more

Ordered both parts from Appliancepartspros.com. The pictures of the website made it easy to order the correct parts. So far I've replaced the grill / kick plate. Took me longer to vacuum out the dust from the coils than it took to replace the part. Have not yet replaced the inner door panel. That will be a project for this coming weekend. Do not anticipate it being a problem to do so. Read more

Purchased a replacement COMPRESSOR. The compress or was a replacement for MFG. P/N 5304478809. The compressor was not an exact replacement. There was no port identification so the connections took a lot of time searching the net and then only the suction port was noted. I had to operate the compressor to be sure of the discharge port.The start relay on the original had no power plug as the new one did so had to improvise by cutting the wiring and adding 1/8 push on clips and then sliding on to... Read more